Jump to content
SAU Community

Whining Noise - Car Stereo


jez NF
 Share

Recommended Posts

Hey...

Installed a sound system this morning in my R33 GTST.....JL splits in the front....JL two ways in the back....Kicker four channel amp and Kicker box subwoofer.....

Makes a whining sound (matches the rpm)....any suggestions / potential reasons why??

Cheers

Jeremy

Link to comment
Share on other sites

it's called alternator whine and caused by voltage differences and u can hear it as high frequency noise....i.e only on your front splits and not on the low frequency subwoofer.

try this

1. do not run power cables and rca side by side.

2. ground each amp independently and do not attach ground from one amp to the next

3. ground the HU to bare chassis metal...not some aluminium bracket on the inside of the dash

4. if none of the above works...use a ground loop isolator on the rca

i'm no expert in the field...but i have had the same problem before and have always managed to resolve it using the 4 steps above.

Edited by fcruz3r
Link to comment
Share on other sites

Hey...

Installed a sound system this morning in my R33 GTST.....JL splits in the front....JL two ways in the back....Kicker four channel amp and Kicker box subwoofer.....

Makes a whining sound (matches the rpm)....any suggestions / potential reasons why??

Cheers

Jeremy

read this and see if any of it makes sense

Noise prevention

Link to comment
Share on other sites

  • 2 weeks later...

Alternator whine is likely to be either;

- a poor ground from amp to chassis

make sure the metal is "bright" (get rid of paint by sanding) and that the ring fitting on your cable is making good contact. this includes your head unit ground cable as well.

- a poor ground from battery to chassis

rarely this in modern cars with small systems, but a good idea to upgrade the factory earth with an additional cable equal to the one from your amp to chassis. again, ensure good contacts.

- RCA interference

poor quality RCA's, RCA's that are "coiled" (due to being too long) or RCA's running near engine looms or other power cables can cause noise. easy way to check here is to unplug your RCA's and connect an iPod with a stero jack to RCA adapter. If your noise is still there, it is power side (earthing) if the noise is gone it is signal (RCA) side.

very rarely is it interference due to the head unit itself unless it is older than the hills or crap quality - like sound4 or something :D

If its a pioneer deck then that will be your problem.

what an ill informed comment.

Link to comment
Share on other sites

Look pal rather then write the same thing as everyone else has I have given the op another possibility. As unlikey as that will be the issue it does still happen. And yes pioneer decks do have a reputation for being fragile. I am speaking from personal experience.

Link to comment
Share on other sites

Look pal rather then write the same thing as everyone else has I have given the op another possibility. As unlikey as that will be the issue it does still happen. And yes pioneer decks do have a reputation for being fragile. I am speaking from personal experience.

from my roughly 25 years in the 12v industry , the Pioneer brand is 1 of the best in terms of features,dependability etc. so your comment isn't valid at all.

Link to comment
Share on other sites

from my roughly 25 years in the 12v industry , the Pioneer brand is 1 of the best in terms of features,dependability etc. so your comment isn't valid at all.

lol my comments not valid. :P

You never heard of a fragile micro fuse common to pioneer decks?

Link to comment
Share on other sites

pioneers are very well knows to blow "pico" and make whining noise

i had issues with mine and it drove me insane then i put a filter on acc side and it stopped it :)

will take some pics to make it easier and hope this can fix your problem as well

Link to comment
Share on other sites

lol my comments not valid. :)

You never heard of a fragile micro fuse common to pioneer decks?

Get over it, you don't know what your talking about, I've installed at least a few thousand pioneer decks etc and never had 1 blow or even a return for problems from bad parts. never.

most issues are install related, bad wiring , shorts, etc

or people dragging to much current from the power antenna wire, use a relay !!!!! or ANY brand of deck will fry

speakers hissing/popping on "deck power" is normally caused by grounded speaker frames to speaker cables or shorted speaker leads hitting the speaker frames common on thin coax speakers, or blown capacitors on crossovers/noise filters

floating grounds thru antenna jacks can as well

Link to comment
Share on other sites

Mine did that.

Adjust the 'gain' on the amp to lowest setting (you won't hear any sound), then slowly increase it until it starts to whine... then back it off a little.

Good luck :)

Link to comment
Share on other sites

Get over it, you don't know what your talking about, I've installed at least a few thousand pioneer decks etc and never had 1 blow or even a return for problems from bad parts. never.

most issues are install related, bad wiring , shorts, etc

or people dragging to much current from the power antenna wire, use a relay !!!!! or ANY brand of deck will fry

speakers hissing/popping on "deck power" is normally caused by grounded speaker frames to speaker cables or shorted speaker leads hitting the speaker frames common on thin coax speakers, or blown capacitors on crossovers/noise filters

floating grounds thru antenna jacks can as well

how bout you prove I don't know what I am talking about rather the spinning shit that you actually work in the audio industry?

Link to comment
Share on other sites

it used to do it in my previous car (integra) when my rca was too close to the ecu.

When i pulled it away, then it wouldn't make the whining noise, but when it was closer, then it would come back.

Oh, and it was a very dodgy home audio install. That could also do it!

Link to comment
Share on other sites

i also have a kicker 4channel amp

same noise, tried everything

somehtings thats even more strange is the fact i have four speakers connected to the thing yet i only need two RCA's connected for al speakers to work

someone explain that one to me as iv messed around with it lots and yea nothing works im guessing i dont have surround sound i just have two sterio sound

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Slap a 460L into the car, send its mum.  
    • So last night pulling away from the lights, I lost power for about 1 second. Bit weird, but I kept driving... 5 minutes later the pump completely dies. When I tried to start the car, the pump won't even prime.  I left the car for about an hour, tried to start it and it all appeared fine. Pump primed, car started, got the fuel pressure I should have.... Start driving home, 5 minutes later it dies again. I'm stuck in a shit spot this time going up hill with a car right behind me, so I just let the car continue to turn over while praying to the fuel pump gods. After about 2 minutes of turning the engine over, the fuel pump came back to life and I got home (only about another 5 min away).  So I've been digging around online, it seems like the 525 fuel pumps really don't like to be run at 100% all the time. I've found quite a few examples online of people killing their Walbro 525 pumps within about a year of usage when they are run without PWM.  So, my pump is an Aeroflow 525 (AF49-1057) and I've been running it at 100% without PWM. I'm thinking the Aeroflow 525 didn't like being run at 100% and has burnt itself up.  I really am sick of dealing with fuel pump issues, my current thoughts are -  1. Use a Walbro 450 and run it without PWM. It seems like these pumps hold up pretty well to being run at 100% all the time. I only make about 350kw and can't see me making any more power any time soon so this is probably a fine option.  2. Get a Walbro 525, run it with PWM. I know doing this will annoy me as I feel like with only 350kw, its extra expense that I don't "need" and I'll be thinking the whole time while setting it up that I should have gone with option 1. I know I'll be happy with this option when its setup and running, its only the initial setup frustration and cost as an issue.  3. Get a Walbro BKS1001 brushless pump. This is the fu*k it I'm already going PWM, might as well go full retard. This option just seems better in every way, with the only downside being cost. But I don't know much about this pump so I could be wrong.  Happy to get everyone's thoughts before I go digging around in the fuel tank again. 
    • Doing it this weekend. For sure this time. Thank you forum gods.  And im running map sensor now with the haltech. Still have the AFMs attached to the mushroom dome shaped air filter things
    • Actually, it is probably pretty legit. I mean, it's still woke feminazi bullshit academia, but you would have to agree that it is very likely that there would be a correlation between wanting a loud exhaust and scoring at the unpleasant end of the scales for dark triad personality traits. The fact that they found it didn't correlate with narcissism and only with psychopathy and sadism definitely shows that the loud exhaust thing is more of a "f**k you" than a "look at me", and I reckon that rings pretty close to most of the dickheads who take it to the extreme. Remember, this is correlation with tendency to be closer to one end of a personality trait scale than the other end. Of course someone who is at the literal opposite end of the psychopathy scale is going to be so considerate of others that they wouldn't even think about wanting to upset anyone with a loud exhaust. So the finding isn't that "you are a psychopath". Just that you score more towards that end of the scale than someone who doesn't like loud exhausts (on average, not necessarily even for specific individuals).
    • Blitz ER34 at some point hopefully, should be allowed in Gr3 if they do.
×
×
  • Create New...