Jump to content
SAU Community

Recommended Posts

Hey everyone, as most of you know I am new to Sydney. My car is in dire need of a tune as it is still running the base Apexi program since rebuild. I was interested in peoples experiences with the different tunning shops Sydney has to offer. I have booked in at UAS for a mixture check ,but, have been put back by the $80 fee(some $30) more than Adelaide, and more expensive doesn't always mean better. I previouly did most of my tuning my self with a wide band sensor and meter. I don't know if any of the shops here are as trusting in adelaide and would lend one out. Sure does save alot of money(6 hours of my own road time and half an hour on the dyno). I think the end result comes out alot better as part throttle mapping can only be done properly on the road.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/
Share on other sites

  • Replies 50
  • Created
  • Last Reply

Top Posters In This Topic

With tuning you really do pay for what you get. CRD in Silverwater, Jim in particular has a reputation as being one of the best tuners around.

Granted their $600 odd charge for a comprehensive dyno tune is above what other places will charge, but ultimately the tune will make or break the car so im my eyes its money well spent.

Ben at UAS is also good with power FC's and should be able to sort you out.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679097
Share on other sites

With tuning you really do pay for what you get. CRD in Silverwater, Jim in particular has a reputation as being one of the best tuners around.

Granted their $600 odd charge for a comprehensive dyno tune is above what other places will charge, but ultimately the tune will make or break the car so im my eyes its money well spent.

Ben at UAS is also good with power FC's and should be able to sort you out.

I was a beleiver in "u get what you pay for " to ,but, myself and a dozen others from Adelaide have had issues with a certain shop who has charged for five hours work only to really spend an hour and a half. To make matters worse there have been issues with overly advanced mapping causing detonation and even cracked ring lans. I had my car tuned and rang back fifteen mintues later because it was detonating at 5000rpm. i was told not to come back in as they didn't have time to re-map. "Just turn the cam sensor back a little, it won't hurt any power they said"

The best tuner I had didn't even work at a dyno equipped shop and charged half as much.(hired dyno time). I have seen countless people throw good money away from not knowing any better. Having rebuilt my own engine, nothing p's me off more to be feed :bs!: to part with ur hard earned cash.

I have also heard CRD are very good.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679155
Share on other sites

A friend was recently charged $750 for a CRD powerfc tune, however, i cannot provide you the full details on what was done, to the best of my knowledge it was just a tune.

On the weekend I was provided with a PowerFC tune by the Hitman. It was a road tune using a wide band a/f sensor and my hand controller.

I'm very pleased with Mat's tune. I have noticeable performance increases throughout the rev range and within every gear. Some comments were made on my previous tune and im sure they were dealt with and rectified where necessary. I still have some detonation which i will hopefully have sorted shortly.

Mat had a laptop with PowerFC software but unfortunately we couldn't get it to talk to the R34 PowerFC. Mat also personally owns an R33 GTSt.

Mat usually charges $300 for a road tune.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679221
Share on other sites

I haven't had my own car tuned and im not aware of anyone that has but im happy with UniGroup's (www.unigroup.com.au) attitude and expertise towards tuning.

I'd happily drop in and have a talk with them when I get my PowerFC.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-679240
Share on other sites

  • 3 months later...

hey boostd i got a mate at C and V performance, they do a really good tune if you like, they keep my car in tune when i got racing and was impressed with what the can do.

also croydon austosports do a whole tune for about 800, but that means when it gets off the dyno your car will be a weapon.

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-850832
Share on other sites

has anyone used hitman since he moved into the workshop at moorebank? do they have a 4WD dyno and does he charge more now? (of course after dyno time is considered)

Nope! its only a rear wheel drive dyno! Dunno if he charges extra...possibly a little bit more ontop of his base $300...

Hes also on these forums - Hitman...so can always PM him :rolleyes:

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-856546
Share on other sites

When I'm not doing it, my car is tuned exclusively by Unigroup Engineering.

www.unigroup.com.au

Yavuz and Valent are very communicative guys and have tuned some very very fast and big dollar cars that are still running hard.

I cannot speak highly enough of their efforts in correcting my tune on the pfc. Less ignition advance, more fuel, same power. They are also happy to tell you exactly what they're doing as they do it which helps you stay in the loop.

I must have picked their brains 20 times since first going there, (phone, email etc) and have found them more than happy to chat.

Yavuz also operates one of the dynos for Dyno Dynamics at Summernats. Expert with the Power FC and how it should be tuned for our cars and your application.

Adrian

Link to comment
https://www.sau.com.au/forums/topic/33875-best-dyno-tuners/#findComment-856626
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • It is a kunfine Android screen . Does anyone know the wirering diagram of the fuga ??
    • just an update to this, poor man pays twice  Tried sanding down the pulleys but it didnt do the trick. Chucked another second hand alternator in the na car which I got for free off my mate and its fixed the squelling. Must have been unlucky with the bearings.    As for my turbo car, I managed to pick up a cwc rb alternator conversion bracket + LS alternator for 250 off marketplace, looked to be in really good nick. Installed it , started the car and its not charging the battery.... ( Im not good with auto elec stuff so im not sure if this was all I needed to do but I verified such by using a multimeter on the battery when the engine was running and I was only getting 12.2v )   I had to modify the earth strap for the new LS alternator , factory earth strap was a 10mm bolt which did not fit the bolt on the LS alternator which was double the size so I cut it off , went to repco bought some ring terminals that fit, crimped it onto the old earth strap and bolted it up to the alternator , started the car and same issue. Ran like shit and was reading 12.2 at the battery.  For a "plug and play" advertised kit thats not very plug and play but alas.  My question is , am I missing something ? Ive been reading that some people recommend upgrading the stock 80 amp alternator fuse to a 140 amp but I dont see how that would stop the alternator charging especially at idle not under load.  Regardless ive pulled it out and am going to get it bench tested by an auto elec tomorrow but it would be handy to know if ive missed something silly or have done something wrong.   
    • My wild guess is that you have popped off an intake pipe....check all of the hoses between the turbo and the throttle for splits or loose clamps.
    • Awesome, thanks for sharing!
    • To provide more specific help, more information is needed. What Android screen? What is its wiring diagram? Does the car's wiring have power at any required BAT and ACC wires, and is the loom's earth good?
×
×
  • Create New...