Jump to content
SAU Community

Recommended Posts

Yeah, money is no problem is just the booking in and waiting etc I suppose ill have to if i cant track it down.

No one thinks gasket ?

an exhaust leak post turbo would just make it noisy, pre turbo would also be noisy but could cause boost to drop, neither would make it run rich or misfire though

  • Replies 53
  • Created
  • Last Reply

Top Posters In This Topic

leaky injector?

never heard of them leaking into the cylinder, I guess its possible though.

other thing to check is if you have a rising rate regulator that the lines haven't fallen off, however that would probably make it lean I think, not rich.

Edited by Rolls

Are they all covered exaclty the same? If so that rules out a leaky injector.

Then u need to do a pressure or smoke test on the entire intake system from airflow meter to inlet manifold.

Just for a quick look if u can check on the fc hand controller in settings and airflow make sure its still set on ur current airflow meter. If theyre stock then it should be on stock. If z32 then on vg30 etc. Its an easy thing to accidently change and sometimes will still run but tune is waay off.

If the intake is all sealed up then the dyno is the next best bet. Give ur tuner some new plugs so he can run it up on the rollers with fresh plugs. So let him putt hem i. Just before he runs it.

It sounds like Lean pop to me, if it's only soon it as it rolls on boost, check the fuel pressure after the filter, I'd just replace the filter for the sake of it. Is the car running stock boost?

It never realy got off boost driving, it was just short bursts up and down my street, the plugs were dark but I think that was because I had that stupid fuel tank breather plugged into the TB lol. Once you found that prob, than it was missing just a's it rolled on boost, the main way I found out it was lean poping, was I turned the boost down from 16psi back to stock, and it got alot better. Hardly did it at all, that's when I realised it was lack of fuel, and a during fuel pump was to blame.

But in saying that if I would have changed the plugs after we change the TB plumbing I'd say the plugs would have gotten light coloured.

Haha oh yeah forgot u did that with the breather. I suppose thats 1 way of getting more fuel in the engine without bigger injectors. Haha just let the engine suck it from the fuel tank lol.

Lol we should do that with my gtr next time it's on the dyno.... Save me heaps of cash on injectors. Bahahaha

Yea it was sucking vapour, it was just running mega rich and backfiring when you lifted your foot. Like a big back fire lol 1 meter flames, like a gun going off. Haha it blow the middle muffler from the inside out hahaha broke all the little tac dipple welds holding it together. I learnt my lession there hahaha

Are they all covered exaclty the same? If so that rules out a leaky injector.

Then u need to do a pressure or smoke test on the entire intake system from airflow meter to inlet manifold.

Just for a quick look if u can check on the fc hand controller in settings and airflow make sure its still set on ur current airflow meter. If theyre stock then it should be on stock. If z32 then on vg30 etc. Its an easy thing to accidently change and sometimes will still run but tune is waay off.

If the intake is all sealed up then the dyno is the next best bet. Give ur tuner some new plugs so he can run it up on the rollers with fresh plugs. So let him putt hem i. Just before he runs it.

All are covered the same.

I think I may have a couple of gaskets which are pretty much f**ked, ordered new ones from nissan.

Will check the intake.

more about my car, has a new fuel pump. plugs are 1500kms old(not gapped to .8), new oil. and its running a haltech so no afm and on o2 sensors!!

althought i blew a hose and covered the pods in oil and i had a few inlet hoses off the other day and saw alot of oil in there. so looks like turbo to inlet manifold pipes will have to be pulled out and cleaned out from all the oil

i was gonna check th igniter module.

i think i have a bad grounding in the engine but...

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...