Jump to content
SAU Community

Recommended Posts

RB20DET Coilpack Loom - good condition, no misfires. - $50

RB20DET Ignitor Module - $50

RB20DET Injector Resistor Pack - $10

RB20DET Turbo + Exhaust Manifold - I never had a boost controller so was running on stock boost. - $100

RB20DET ECCS Inlet Manifold - complete with injectors, fuel rail, throttle body etc. - $100

PM/SMS. 0438858813.

RB20DET Coilpack Loom - good condition, no misfires. - $50

RB20DET ECCS Inlet Manifold - complete with injectors, fuel rail, throttle body etc. - $100

PM/SMS. 0438858813.

RB Flywheel $50

Gearbox Sandwich Plate $10

R33 Speedo Sender $50

Clutch Throwout Bearing (NEW) $35

RB20DET Gearbox Yoke $50

SECO Pressure Plate $50 (Jim Berry rebuilds these for his clutches)

R32 Starter Motor $20

RB20 Dump $20

NISMO Clutch, pressure plate is machined, $50

RB20 Ignitor Module $50

RB20 Crossover Pipe, with BPV attached $50

RB20 Turbo + Exhaust Manifold $100

Exedy RB Chrome Moly Lightened Flywheel (Freshly Machined) $350

post-59195-1282812432_thumb.jpg

post-59195-1282812453_thumb.jpg

Xtreme Heavy Duty Cushion Button Clutch Kit for RB $300

Driven 15,000 kms, upgraded due to more power

post-59195-1282812540_thumb.jpg

post-59195-1282812572_thumb.jpg

post-59195-1282812639_thumb.jpg

post-59195-1282812688_thumb.jpg

post-59195-1282812610_thumb.jpg

post-59195-1282812732_thumb.jpg

Lightened Flywheel + Clutch Kit together $550

PM or sms/call for info 0413 733 433

located in adelaide, aberfoyle park

all offers considered.

R32 Tein HA Coilovers

Damper and Height adjustable

$500

R33 Tein Ha Coilovers

Height adjustable

$500

R33 Cat back exhausts

Twin pipe setup, $300

Kaikamoto (spelling) $300

R32 Indicators (orange)

$100

RB20/Rb20 S1 Coilpacks

$100

R33 Turbo/Manual Diff

$150

R33 Brakes, Front and rear

$500

R33 5 Stud hubs, Front and rear

$80

Also Check:

http://www.skylinesaustralia.com/forums/R3...13-t315266.html

http://www.skylinesaustralia.com/forums/Ni...13-t318919.html

http://www.skylinesaustralia.com/forums/R3...ff-t320107.html

Edited by JiN_MaN

For Sale:

Left and Right hand side 12 inch subwoofer enclosures made of fibreglass, fits into the corner of ur boot looks good.

Fits r34, dont think u will find them in s.a!

Asking 180$ for the pair!

For Sale:

Left and Right hand side 12 inch subwoofer enclosures made of fibreglass, fits into the corner of ur boot looks good.

Fits r34, dont think u will find them in s.a!

Asking 180$ for the pair!

Got pics mate?

17*8 Drift R by ROH Megs 5 spoke 114.3 pattern.

Well looked after mag wheels. Black power coated spokes with polished lip. Paint on one of the wheels are comming off in the centre but other three wheels are in perfact condition. Two of the wheels have very very small gutter rash see picture, unoticable. $300.

Also have r33 gtst stock closover pipe with GFB BOV great working order. $100

R33 gtst stock cooler great condition for $50.

Feel free to contact me here or 0412724796.

cheers.

P.s I was trying to upload some pictures but somehow it got lost. I can suply pictures up on request via PM. ta

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
    • Welcome mate. Any pics? Even with a DE I'd be well happy if I had that as a 1st car. 
×
×
  • Create New...