Jump to content
SAU Community

Turning Off Traction Control On R34

Shnid
 Share

Recommended Posts

GTSBoy Grand Master

GTSBoy

Posted
Posted

No, but you do have the same part (dashboard) as cars that do have TC and you have the same globe test wiring as everyone else. The lights all light up, not under the control of their various ECUs, but by a simple circuit that puts power on all of them with the ignition on and nothing else running. It's so you can see if the globe is working or not.

Legionnaire Collaborator

Legionnaire

Posted
Posted

By TC light you mean "slip" light I'm thinking?

GTSBoy is correct, it's there so that Nissan could unify dashboard diagnostic and indication circuitry. It's meaning as an indicator is different depending on model though - on GT-t's it blinks when traction control kicks in, on GT Fours it blinks when TCU detects inequality of wheel speeds and engages ATTESA.

IMPORTS ONLY Community Regular

IMPORTS ONLY

Posted
Posted

Your cluster was probably replaced with one from a car that had traction control. From factory the bulbs would be removed if the car didn't have TC.

this makes sense but im almost certain it hasn't been changed, previous owner possibly replaced leds in the dash and added that one back in again

and not its not the slip light as i have that also

but yeah i was just curious as to why it would be there still if there is no TC on all N/A models which have a different cluster with out the turbo made up for them anyway youd think they'd take the TC light out too

brodielezgt Collaborator

brodielezgt

Posted
Posted

You can switch it off and unplug it but of you still rip the hand brake hard and flick it right out it will still come. Find the fuse and pull it out but light mite Tay on

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • 33GTRV
      Rb26 iron block limit

      By 33GTRV · Posted

      Here is a recipe. Sonic blocks till you get one that has a good enough bore. Get a torque plate and block brace, use your choice of fasteners (arp ect) bolt the thing together empty, half fill it and let it cure. Release it when it has, go to a REPUTABLE RB Builder and get the thing line bored/honed and cylinder honed to size, then wash. Once its all clean and dandy, wash and blow it out again. Then again.  Assemble said engine to your desired clearances with oil control mods, gasket to suit desired CR/Squish ect. Attach your extended sump with proper trap door oil baffles and head drain plumbed to sump with a SUMP BREATHER SYSTEM. Build your front diff with a decent LSD, rebuild your transfer case with a few extra plates, more than likely replace your tailshaft centre bearing and tighten up the rear diff. Tune to minimise excessive midrange cylinder pressure (timing unless you like to split bores and rebuild engines) Enjoy your engine, but hate the fact you are now destroying engine mounts, gearboxes, gearbox mounts, diff output flanges and driveshafts, diff mounts, tailshafts and front CV's.   Disclaimer.... Ive never done any of the aforementioned stuff.......
    • GTSBoy
      R32 GTS (RB20DE) Injectors Replacement

      By GTSBoy · Posted

      440s will support well over 400HP on petrol, which is a decent place to be for an RB20. 230+rwkW. Will be a safer bet for idle/low load. 550s would be nice for the extra headroom. I've made the same decision with mine (Neo25). 1000s are probably too big for the Nistuned ECU, so I have some smaller ones.
    • GTSBoy
      RB25DET Series 1 & Series 2 Gearbox Identification

      By GTSBoy · Posted

      thumbsup
    • AdiR34
      Did tie rods. Steering now not "springing" back.

      By AdiR34 · Posted

      Appreciate everything guys. I did go ahead and get an alignment... most of my complains are solved. Car is not perfect, but it's good enough. If I notice uneven tire wear or anything I'll just take everything back to stock.  Thanks again!
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      They still have not shipped the 550cc injectors as they weren't in stock, so in theory I could ask to get the 440cc ones instead, if those work better in my scenario. They're the same price so really shouldn't be an issue. Unfortunately I am not so knowledgeable in most parts of tuning so I wasn't sure what's best to choose between the two. 440cc ones are the lowest they have (not in stock, but available to buy nonetheless).
×
×
  • Create New...