Jump to content
SAU Community

Awd In R32 Gts-T

Plan-FAILURE
 Share

Recommended Posts

Plan-FAILURE Rising Star

Plan-FAILURE

Posted
  • Author
Posted

Way too hard, the ATESSA system is rather complex with wiring and pumps and sensors etc.

Cheaper and easier to buy a GTS4.

Yeah I thought as much, I prefer RWD but it would be nice to have the option to switch for 1/4 mile runs and the like ay.

  • Like 1
  • Nope 7
ZED X Rising Star

ZED X

Posted
Posted

Its another one of those Buy a GTR scenarios.

The amount you'd be looking at to convert a gtst to 4wd would be near to the point where you could sell your current vehicle, then buy a GTR with the remaining cash u would spend on the conversion.

GTS4's arnt all that expensive these days anyway.

  • Like 3
The Dan Grand Master

The Dan

Posted
Posted

As above - the ATTESSA system is extremely complex. Just the ECU side alone is a headf*k. Plus not many people know too much about it to be able to offer advise when you're half way through it so you'd be stuck if you started it and couldn't finish. GTS4 or GTR :thumbsup:

  • Like 3
  • Nope 1
Plan-FAILURE Rising Star

Plan-FAILURE

Posted
  • Author
Posted

Its another one of those Buy a GTR scenarios.

The amount you'd be looking at to convert a gtst to 4wd would be near to the point where you could sell your current vehicle, then buy a GTR with the remaining cash u would spend on the conversion.

GTS4's arnt all that expensive these days anyway.

Yeah I think ultimately I'll hold onto my R32 GTST and eventually buy an R32 GTR. GTST will become the track/daily drive, GTR will be the weekender.

  • Like 1
  • Nope 5
Strik3r Experienced

Strik3r

Posted
Posted

you would need:

AWD gearbox (~$1000)

Front sump and diff from an rb26 ($400)

A custom adaptor plate to bolt the 26 sump onto the 25/20 block. (approx $800-1000)

G sensors (~$1000 new, hard to find at wreckers)

Front drive shafts ($?)

Attessa ECU ($?)

Attessa Pump ($?)

Wiring loom for Attessa ($?)

and probably about 20-30 hours labour @ ~$100 p.h...

  • Like 2
ZED X Rising Star

ZED X

Posted
Posted

Yeah I think ultimately I'll hold onto my R32 GTST and eventually buy an R32 GTR. GTST will become the track/daily drive, GTR will be the weekender.

Sounds like a good plan to me :)

I'm planning to pick up a 32 gtst at some stage in the future for a track build. Would love to track the GTR but im not made of that soft of money :)

  • Like 2
Thebumfluffking Rookie

Thebumfluffking

Posted
Posted

dont gts4's come with all awd??

it would be a much cheaper option then trying to convert.

you would need:

AWD gearbox (~$1000)

Front sump and diff from an rb26 ($400)

A custom adaptor plate to bolt the 26 sump onto the 25/20 block. (approx $800-1000)

G sensors (~$1000 new, hard to find at wreckers)

Front drive shafts ($?)

Attessa ECU ($?)

Attessa Pump ($?)

Wiring loom for Attessa ($?)

and probably about 20-30 hours labour @ ~$100 p.h...

Spurdo Experienced

Spurdo

Posted
Posted

dont gts4's come with all awd??

yes. thats what the name would suggest.

i couldnt agree more that its a waste of time and money. very much a "buy a gtr/gts4" scenario as it would be miles cheaper and prevent you from trying to top yourself from the stress of working it out.

that said, i have seen it done before here in christchurch. it was for sale a while back. i didnt bother asking how much time and money it took.. didnt want to know.

if you mainly use rwd and would only use 4wd once in a blue moon then would it be worth the permanent weight penalty of 100-150kg?

Guest
This topic is now closed to further replies.
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • TurboTapin
      boost source Size Garrett gt28 gen2

      By TurboTapin · Posted

      You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • Kinkstaah
      Mistakes were made, my R34 Story

      By Kinkstaah · Posted

      So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • QB6SAGR
      Battle of the broken skylines

      By QB6SAGR · Posted

      Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • cosline
      R32 gtr transmission strength, billet plate

      By cosline · Posted

      Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Rezz
      Spotted on the street....

      By Rezz · Posted

      Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...