Jump to content
SAU Community

Recommended Posts

Well I did ask in another thread, but this is critical to getting my car running and today I spent 1hr 40 minutes on two busses and walked 2km to get to work.

The two pin plug on the RB25 near the ignitor has one white wire which is the coil +, it also has another Black/Pink wire which seems like it is in the coil pack loom. With a wasted spark setup this is obviously connecting cylinders 1 and 6 together... what does this wire do, and will it hurt it having it connected to both 1 and 6 coil power sense wires?

Cylinders 2 and 5, 3 and 4 both had spark... and the car ran on four cylinders.. I will have to swap the coils around today and test to see whether it was the coil pack being faulty but I doubt it. I have also gotten better connectors which plug into the coilpacks snugly today too. Please I need some help with this one :( To repay I'll write a guide on MSD Commodore coils into R33 RB25DET S1.

Edited by Justlikemusic
Link to comment
https://www.sau.com.au/forums/topic/357337-wasted-spark-fail/
Share on other sites

VS Commodore coils into R33 RB25DET S1. I hacked the loom up so going to keep the loom I made and make a six pin plug after the ignitor. I think I might just get a set of splitfires to save my headaches of trying to diagnose why it's running like crap. For now tomorrow i will put it back like it was.

Thought MSD coils and Eagle 9mm leads would give a better spark, and cheaply cure my problem. While I've only so far used standard commodore coils... I will probably just buy some splitfires and see how they go.

Thought MSD coils and Eagle 9mm leads would give a better spark.

compared to what?

factory ignition has been well proven to 400rwkw.

this is just like your other thread about weight reduction and removing A/C so your car stops overheating.

seriously, out down the crack pipe.

Was ur car missfiring on idle with old coil packs?

Nope only under boost.

And I think you got it misunderstood.... the air con removal was more for the benefit of the car in general. Tyre wear, less weight on the front end, more air flow to the radiator. I never said it would make my car 'stop' over heating.

Edited by Justlikemusic

Dude, I read your other thread and thought wtf....and here we have the result...put the stock coils back on, clearly your problem was not your coilpacks...a faulty coilpack will generally give you a misfire or crappy idle which may clear under load...you had some sort of power loss, not a misfire of any kind....I find it highly unlikely you had a problem with your ignition system...as Nismoid said, factory setup good for big numbers...sh1t, even a single coil setup on a VL can make 300rwkw+....Nissan weren't idiots when they designed these things.

Change it back.

Back to stock in a hurry. Diagnose it properly before you try to change it....

Let it be known, you should never ever try to fix a problem by replacing the suspect item with something that you do not know works. Always diagnose and repair the problem in its original working form before trying to change away from what you know DOES work.

In your case, if your heart was set on running commonwhore coils, you should have dianosed the problem and proven it was your coils before trying to convert over. Maybe pay another member $20 to come over and let you use his non butchered coils and coil pack harness to see if it will start and run properly.

Do that and you will know what to do. Put a thread in the relevant state section requesting the above before you waste any more time and money.

P.S. walking 2KM is a joke of a thing to complain about, you can do it for a couple more days.

running a wasted spark set-up would be fine if you had a after market ecu to control the dwell time on the coils/ igniter. too much dwell and the igniter will get red hot and prematurely fail, too little dwell and the misfires and running like crap are your friend, a wise person once told me ;)

Put standard setup back in today and the car wont idle... cranks and sorta idles while im cranking, but as soon as I stop it idles for two seconds and stops...... I reckon the problem is the ground cable, at least that's what Im going to check next.

  • 2 weeks later...

I am thinking it could be the spark plugs causing some of the issue... however something is causing them to foul up.

Car will idle like it has a lumpy cam and occasional backfire... I started the car without the AFM connected and it run. I had the car running with the AFM connected, then unplugged it and it stalled. I figure this means it's ok?

Will be replacing plugs today and checking. I had them very clean when I started it up after I tested the coils/plugs/loom. They got dirty quick.

I figured all the plugs are getting black and they are firing on all cylinders so it has to be some sensor that's screwed. Will be checking all hoses for leaks and taking a good look today before having to shell out for splitfires on tuesday.

post-49098-0-13506200-1301092552_thumb.jpg

Well I replced the igniter first up, then I just bought a replacement AFM today, still no change. So $300 later I have two good spares at least for future problems...

Going to buy coilpacks and standard loom on Tuesday and try again. Probably will just get JJR ones for $400 i think. Or yellow jackets...

Put some decent plugs in and get some yellow jackets.

If you're getting misfire, a popping sound, on high boost then that's almost certainly the problem. Gutsy trying the holden coils, but yellow jackets are only round $400, have 2 years warranty, and have been proven to be pretty effective

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
    • @Stringycheese  Have you only gone to the one blue slip workshop?  There will be a heap of them where ever you live, good odds that the next place you go to will pass the car.  Unfortunately (or fortunately?) every blue slip / engineering workshop will be different and will be happy passing or failing different things - despite working from the same set of rules. It's kinda like 2 lawyers arguing over a piece of legislation, each saying their interpretation is correct. Might seem strange that this happens when it comes to getting a modified car passed, but this is very much a thing. A big part of the game is finding an engineer / workshop that is on the same page as you.
    • Bah. I daily mine. ~60km per work day, 10-12 thousand km per year. What's the point of having a dirty old Datto and leaving it in the shed. It needs to be driven and enjoyed while the govco allows us to do so. It will only be a few years before we're forbidden to even start up internal combustion engines.
    • Judging by that spring perch and the normal looking spring on it - not a coilover. Well.... it is a coilover, just a stock format coilover, rather than what everyone calls a coilover.
    • Yes it is. We get stock from Nismo directly. I'm happy to take photos/video of it as proof before I ship it with timestamps or whathaveyou.
×
×
  • Create New...