Jump to content
SAU Community

Recommended Posts

Posting this on behalf of my gf. She is looking for a flat mate.

2 Bedroom unit located in Woolooware.

Polished wooden floors, big kitchen, wireless internet, spacious room with built in mirrored wardrobe . Place is furnished so all you need is your bed room furniture.

Very close to Cronulla beach, shops and Woolooware train station.

Rent: $340/ fortnight + utilities quarterly (electricity)

Im after a female flat mate. Im a shift worker and full time uni student so need someone who is neat, tidy and not a party animal! Also non-smoker.

Place is available from end of April so please contact me ASAP if you are interested.

Joanne

0403 861 272

Edited by siddr20
Link to comment
https://www.sau.com.au/forums/topic/358973-flat-mate-wanted-female-only/
Share on other sites

ahhh tws.... memories... sweet, sweet memories. The world seemed a lot simpler back then ;)

i see a 33 getting around penrith with the old kanji sticker down the the front window from time to time, I'm almost certain they have no idea what it means.

I don't have any shots from back then, but i'm pretty sure i know the minh shot you mean hahahaha

ahhh tws.... memories... sweet, sweet memories. The world seemed a lot simpler back then ;)

i see a 33 getting around penrith with the old kanji sticker down the the front window from time to time, I'm almost certain they have no idea what it means.

I don't have any shots from back then, but i'm pretty sure i know the minh shot you mean hahahaha

There's a black 33 GTST i saw a few months ago with it on the rear windscreen on the hume hwy near bankstown. Still out there!

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...