Jump to content
SAU Community

Recommended Posts

Hi All,

I've been trying to find safe/normal operating temperatures for an RB25det, a good idle seems to be about 80c, but what is considered a safe temperature when you start pushing or tracking the car?

After just fitting a replacement engine to my 33 I've been watching the temps very carefully, my dash gauge never moves above 1/4 no matter how hot shit gets so I've been using a consult cable to read from the ecu, currently running water through the system as the engine has only been in for a couple of days and I'm checking for leaks etc. City driving sees 80-86c, I was at wot in 3rd for 15-20 secs heading up a steep hill right after a spirited drive and temps reached 98c, obviously water becomes fairly useless at this point so I just coasted down allowing it to cool.

Is +100c normal for an RB being driven hard? If so I guess I should switch to some coolant asap.

Link to comment
https://www.sau.com.au/forums/topic/359460-rb25-operating-temperatures/
Share on other sites

You talking stock radiator? I wouldn't be tracking with a stock one. I mean you can in a stockish car, but its not really ideal.

With a aftermarket radiator, my RB25 and RB26 both sit between 67-75 putting around. Only giving it an absolute gut full will see upwards of 80+

IMO invest in a radiator if you are see 98, thats up there.

  • Sad 1

Hi All,

I've been trying to find safe/normal operating temperatures for an RB25det, a good idle seems to be about 80c, but what is considered a safe temperature when you start pushing or tracking the car?

After just fitting a replacement engine to my 33 I've been watching the temps very carefully, my dash gauge never moves above 1/4 no matter how hot shit gets so I've been using a consult cable to read from the ecu, currently running water through the system as the engine has only been in for a couple of days and I'm checking for leaks etc. City driving sees 80-86c, I was at wot in 3rd for 15-20 secs heading up a steep hill right after a spirited drive and temps reached 98c, obviously water becomes fairly useless at this point so I just coasted down allowing it to cool.

Is +100c normal for an RB being driven hard? If so I guess I should switch to some coolant asap.

I have an R34 - usually runs 85-89c - on hot days it runs 90-103c depending on load.

Hard driving on a moderate day is low 90s

I'm running Castrol 33% coolant.

My car is stock.

Edited by iseekool

Normal street driving on belter hot days, the highest I've seen in either car was 95deg, nothing to worry about.

The 32, on a 40+ day and a good 2 min skid, the highest I've seen is 105deg which was fkn hot but still didn't throw any coolant.

Coolant, under pressure, isn't going to boil until about 110deg. If you're seeing about 100deg or higher on the street or highway, then you've got issues that need addressed.

From my experience, RB's like to operate at about 80deg (RB20/25non-neo/26), they run a 76.5deg thermostat. The neos seem to want to run a bit hotter (probably due to emissions reasons) and they run an 82deg thermostat.

Edit: I also had way better results from a stock GTR radiator than the 50mm chinese alloy thing I used to have.

Edited by bubba

I have an R34 - usually runs 85-89c - on hot days it runs 90-103c depending on load.

Hard driving on a moderate day is low 90s

I'm running Castrol 33% coolant.

My car is stock.

It's worth noting that R34 have a much higher thermostat than the R33 (off the topic of my head I beleive it starts opening around 80-82C and fully open by 95C?). I believe these hotter running temperatures were done as part of the LEV modifications (ie: lower emissions) ..

My R34 sees similar temperature ranges as above on a stock radiator (using tectalloy 100 coolant), fresh thermostat, recently changed fluid, etc. Planning to put a bigger radiator in within the next few weeks. I will note I saw much higher temperatures (105+ on hot days stopped in traffic) when I had a nismo radiator cap fitted - not sure why that is.

Coolant doesn't make your engine run cooler, all it does is increase the boiling point. In fact, due to Ethylene Glycol being an oil product, it actually reduces the thermal efficiency of water. Only products that reduce surface tension are going to reduce temps

  • Like 1

I boiled all the water/coolant at my last track day. Would have been 120degrees PLUS.

Hopefully my dedicated RB26 r32 sedan track car never sees boiling point, not a nice feeling wondering if youve ruined your engine.

If I didnt have a thick headgasket on my RB25 (stock bottom end, ported head, gt3076) Im sure it would have shagged the engine......

It could be your stock radiator is blocked with sludge. best to replace it with a thicker dual/triple core aluminium 'race' item. The one in my

RB26 is from ASI in melbourne @52mm thick, the RB25 radiator is a Koyo 40mm thick item

Thanks for the replies guys.

I have an R34 - usually runs 85-89c - on hot days it runs 90-103c depending on load.

The NEO does run a bit warmer than the earlier 25's, my thoughs were inline with R31Nismoid and bubba, for a '96 RB25 I was expecting to see 80-90c but had never monitored it after a hard drive to know for sure.

Current radiator has had various mixtures of chemiweld and oil through it in a previous life, even though it's been flushed it's probably rooted. I guess I'll be looking at an aftermarket radiator for peace of mind :thumbsup:

nissan thermostat for all RBs except 34s is 76.5C, but the thermostat is in the bottom hose (coolest point), temp sender is in the top hose, which is the hottest point of the system.

i see the same temps as nismoid, high 60s to low 70s, but thats not normal, seams to be a 31 thing.

I always thought it just to be a 31 thing with added space in engine bay and around the front of the car aiding airflow.

My GTR does as well though with a decent after market rad, which I found interesting and dispelled that one.

  • Sad 1

Mine sits at ~82 during a normal day without A/C & will go up a couple of degrees when stuck in traffic.

In a 38C+ day with A/C on, it will go over 90C when stuck in traffic but will drop back down to about 85 when moving at decent speed again.

This is with a stock radiator, recently got the plastic top tank repaired & rad cap and thermostat replaced.

  • 3 months later...
  • 7 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I can ship Nismo floor mats to you: https://www.oemsoko.co.jp/products/nismo-floor-mats-for-skyline-r33-bcnr33-stagea-wgnc34?_pos=1&_sid=9278c1467&_ss=r  
    • Here's the link: https://www.amayama.com/en/genuine-catalogs/epc/nissan-japan/stagea/wgnc34/6642/misc/G49?frame_no=WGNC34-137122 What you think about it? The same product i found on nengun: https://www.nengun.com/oem/parts/40567/MiPwn5qAMfCfmpxHNDnwn5q9MDAx8J-QiW9sZC1qcC0xMTAtRzQ5LS0wMDE/Floor+Carpet+%2F+Mat+2/0688339eba149c19 Bot i have spoken to 😅 ensured me, that mats are 100% original, oem product. I have my doubts. I also heard what you mentioned, that nengun often offers items that are actual not available... On the other hand mats i found on japanese yahoo or ebay are in poor condition and still quite expensive so i'd rather wait for some better offers. My location - Poland. We literaly don't have ANY market for used Stagea parts so need to search outside Europe.
    • You can’t see much on the other side as the lcd is there I don’t think it’s the same as the m33 beside it as the markings on top is not the same was hoping someone had a good quality photo or if they just happened to have the unit in hand, quickly take the cover off and take a photo to clearly show the marking on top to identify the diode   the unit is currently with an electronics repair shop so I can’t take another photo at the moment hopefully they are smart enough to know if it’s a zener diode or not
    • I'd be very surprised if you can buy new OEM mats. But if you can, I want some too!  Do you have links to the variations you found? Also, where are you located? I found that Nengun is happy to list items to purchase but when you do buy them you'll get an email that it's actually discontinued. As far as I know the variations in floor mats are different colour schemes as well as automatic and manual having a slightly different shape. The automatic ones fit into a manual car without issues, but I think you'd have trouble fitting the other way around. I have photos that show the shape difference if you care. FWIW I bought sets of used floor mats in decent condition at yahoo auctions.
    • Hi 🙋‍♂️. Just bought my Unicorn but the interior need some minor work so it would match my expectations ;). I noticed it is hard to get used oem floor mats in good condition so i started to dig if there's any chance to buy set of new ones. I found two websites - nengun and amayama and it looks like one can still buy factory new floor mats in Japan, but thers a small issue. Some mats (i assume genuine, oem ones) are marked as G4900 and these are "discontinued". The ones you can buy are marked as G4911 but i have no idea if these are also oem, made by other producer or some lower quality replacements that looks entirely different. Can anyone help? 😃  P.s. there is also some strange indication - 0V005, 0V015 and 0V505. Any idea what does it mean? Would appreciate any help with this 🙏
×
×
  • Create New...