Jump to content
SAU Community

Recommended Posts

hey,

im just about to buy my first R33, took it for a test drive yesterday and everything is running fine, only one issue...

3rd gear pops out when you are slowing down (no power on it) and it drops below about 2 grand,

just wondering how much time and effort / dollars this will take to fix?

at the moment iv offered him 11,000 for it but will probly drop this according to the above problem.

thanks for any help

Link to comment
https://www.sau.com.au/forums/topic/362387-3rd-pops-out-at-low-rpm/
Share on other sites

popping out of gear is usually caused by overly worn selector forks. either way its a complete rebuild to fix which will likely cost a few grand , or just replace with a 2nd hand box for cheaper, but you have no way of knowing what condition its in and how long its likely to last. given that all these gearboxes are getting aged now and all have seen their share of abuse, i think rebuild is better in the long run unless you dont plan to keep the car long.

just for reference all, the reason they pop out is a detent spring problem, this holds slight pressure against the selector hubs and selector forks,.jumping out could also be a broken snap ring on the main shaft holding the gear clusters in postion.. bit late now ..lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Saw this video today from Adam LZ.    Long story short is he is claiming that the load from the engine fan once the fan clutch heats up(engaged) is increasing the getrag rattle(at idle) when you don't have a dual mass flywheel.  Before I go buying an electric fan setup .... Anyone heard of this ?    I must admit when my car is cold the getrag is pretty quiet and I do notice the rattle after it is all warmed up. I've always assumed this is due to the gearbox oil temp and tolerances of metal.       
    • Yep it sure does.   Tone wheel lines up in the same spot perfectly.    
    • Something I meant to say when we were chatting the other night about having an open trailer floor being great to work on a car, but you've never used the feature... It's a great place to park a car after doing suspension component changes, and do the tightening of all the bushes with the car sitting at full ride height. Especially when you don't have a 4 post hoist!
    • That is way more science than even I would use. I just eyeball it, not even accounting for the non-verticality of the tape measure when held on the lip and the centre at the same time. +/- 2mm is good enough for the girls I go out with.
    • So, before putting them in I need to understand the stock ride height. This is how I measured it: First, check the diameter of the wheel's centre cap, it was 52mm. Then put a piece of masking tape approximately across the centre and measure 27mm (half) from at least 3 sides to get a reasonable idea of the centre of the wheel cap. Mark that with a horizontal line as one measuring point. Then, directly above the wheel on the guard, put another piece of masking tape in approximately the centre. Use a string line to find out the point on the guard above the centre of the wheel cap and mark that. Then it is simple, just a tape measure to check the distance from centre of the wheel to the centre of the guard. Final results where  LF: 381mm RF: 379mm LR: 401mm RR: 400mm Pretty even considering they are 120,000klm old factory springs, lets call that 380 front and 400 rear.
×
×
  • Create New...