Jump to content
SAU Community

Recommended Posts

  • Replies 75
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

This is no good, silly yes but he has tried to inform his fellow import owners of dodgy dealings, good I think why not help the poor guy out and delete the thread??

Hey, he knows full well what his conditions are on here. I would not have too much of a problem if he posted it in the wasteland.... (even tho he is really annoying at times)

I still don't believe him however.

generally people who are going to commit suicide do not tell strangers they are about to do it.

i have a few friends who have chosen to commit suicide over the past coup[le of years, all of them young (20ish), and no one saw it coming. they certainly were not attention seeking like this person.

I've spent plenty of time with people with depression, many of whom have committed suicide, and I can tell you now that there's no rhyme or reason to how people do it or what they do or say leading up to it. I certainly wouldn't be playing the "well that's not how people act before they commit suicide" card.

This wasn't a swipe at you personally btw - more at the people who think others are bluffing when they threaten suicide and try to call them on it. Like I said, I've had friends commit suicide and I'd much rather look like a dick for defending an attention-seeker than be going back through my posts wondering if something I said contributed to another human being taking their own life.

Actually we all should have a dig and f**K this wanka bomba off this forum for the benefit of all, the sooner we get rid of him the better.

And that's fine, IP ban him if necessary.

There is a good chance that he was just trolling again....

And with the suicide thing normally people don't say anything before offing themselves.

See above.

I've spent plenty of time with people with depression, many of whom have committed suicide, and I can tell you now that there's no rhyme or reason to how people do it or what they do or say leading up to it. I certainly wouldn't be playing the "well that's not how people act before they commit suicide" card.

This wasn't a swipe at you personally btw - more at the people who think others are bluffing when they threaten suicide and try to call them on it. Like I said, I've had friends commit suicide and I'd much rather look like a dick for defending an attention-seeker than be going back through my posts wondering if something I said contributed to another human being taking their own life.

And that's fine, IP ban him if necessary.

See above.

Iron Chef, i think i will leave this thread well alone from here on in. >_<

Shannon

As much as everyone's having a laugh Edward Lee's do enjoy going after forums/individuals that talk about them negatively (no matter how true it is.) As always, buyer beware. You only have to watch their videos on Youtube to get an idea of them for yourself.

you have a point iron chef. i am regretting encouraging him now. yes i would feel terrible if i thought my comments contributed to such an act actually happening....

but give his track record im not going to beleive what he threatens just yet.

do your parents realise your a fcuk wit?

like what do they think your doing on the interenet? they surely could not believe your intelligent enough to contributing information to a forum?

ive never met you and i can tell your a complete dumb fcuk!!!

http://www.supraforums.com.au/forum/showthread.php/39154-Edward-Lee-Parramatta-Warning

Found another thread like mine, but with much more proactive responses.:teehee:

Maybe you should join Supraforums

i take 56damage in a game of L4D2 on normal.

I didn't know you played the dead...

Should have a match sometime. Master hunter right here :)

Guest
This topic is now closed to further replies.



  • Latest Posts

    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
    • I wanted to try and preserve the front bumper as long as possible, they're not cheap and are made to order in Japan. Taking inspiration from my previous K11 Micra build where I made an undertray for the Impul bumper, I did the same for this BN Sports bumper but a little slimmed down.  This time round I only made a 'skid plate' (if that's the correct wording/term) for just the bumper surface area, the Micra version covered the gap like an undertray. Starting off with a sheet of mild steel approx. 0.9mm thick 4ft x 2ft in size. I traced around the bumper, cut it out and cleaned the edges. Luckily I was able to get two halves from one piece of metal In the video I installed it as is, but I've since then I've removed it to spray and add a rubber edging trim. The rubber trim is suitable for 1-2mm and it's a really nice tight fit. The bolts had to be loosened due to the plates being too tight against the bumper, the trim wouldn't push on I used some stainless M6 flat headed bolts for a flusher finish (rather than hex heads poking down), I believe this style fastener is used for furniture too incase you struggle to source some. The corner's are a little wider, but this may be an advantage incase I get close to bumping it  The front grill got some attention, finally getting round to repairing it. Upon removal one fixing pulled itself out of the plastic frame, one side is M8 that fixes inside of the frame, where as the other side is M5. Not knowing I could get replacements, I cut down an M8 bolt, threaded it inside the frame along with a decent amount of JB Weld.  The mesh was replaced to match the bumper. One hole on the bonnet/hood had to be drilled out to 8mm to accommodate the new stud, once the glue had set it could be refitted. I think the reason the grill was double meshed was to hide the horn/bonnet latch (which makes sense) but I much prefer it matching the bumper Bumper refitted and it's looking much better IMO The Youtube video can be seen here: https://www.youtube.com/watch?v=bVZP35io9MA
×
×
  • Create New...