Jump to content
SAU Community

BIG MEET - Friday night.

R31Nismoid

By R31Nismoid,
in Victoria

 Share

Recommended Posts

Jamezilla Grand Master

Jamezilla

Posted
Posted

Is a very fair call E.

I'm still taking everything they say with a grain of salt - but what can we do? Is better to inform them of the meet and hope they behave, than have a unit stumble across it and call in the SWAT team.

The officer I spoke to said 'if you guys play the game, then we'll play the game' - in reference to us behaving ourselves. Lets hope they treat this as a valuable PR exercise - and perhaps a bit of education to the Po's - that we're capable of having a civil, organised meeting with no trouble.

That said - they haven't exactly bent over backwards to incite our trust in the past, so if you are concerned - don't bring your car :D

Also:

SGSKY: I would like to apologise for my unfriendly response in the previous post. Was having a bad day. You asked a fair question - and I unleashed. Sorry :)

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

Wardest Mentor

Wardest

Posted
Posted

I spose we can only hope. At the very least you've done the right thing and informed them of the meet. It gets it out in the open and proves we aren't trying to hide anything.

In any case, I have other plans that night so I won't be there. However for me to bring the car to any sort of meet the current climate with the Police will need to warm up a quite a bit more than the frosty chill which exists now.

This is a step in the right direction tho.

All the best for it fellas. I hope I'm wrong about the police treating it as one big the sphincter of the universe Shoot.

Wardest Mentor

Wardest

Posted
Posted
you have to remember tho that if u act like a spastic u deserve to be bent over like one... even outside the meet on the way there or home.

Steady there Nark, I couldn't agree more. I would be shocked and dismayed if any SAU member did act like a spastic. I'm positive everyone would be on their best behaviour.

However this would not stop the police handing out EPA notices and canaries at will, or hassling ppl just because they feel like it.

Most ppl would agree that simply driving up the road to the shops can be enough to attract unwanted attention from the Law.

inark Grand Master

inark

Posted
Posted
Steady there Nark, I couldn't agree more.  I would be shocked and dismayed if any SAU member did act like a spastic.  I'm positive everyone would be on their best behaviour.

However this would not stop the police handing out EPA notices and canaries at will, or hassling ppl just because they feel like it.  

Most ppl would agree that simply driving up the road to the shops can be enough to attract unwanted attention from the Law.

that all comes down to bad PR for them... which is where contacting ACA and the like comes into play

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • JC71
      new 1.5 LSD issues/concerns

      By JC71 · Posted

      looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Matt Z
      SAU NSW - Archies Flame Grille Meet & Cruise to Kurnell

      By Matt Z · Posted

      Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Ozdavroz
      WTAC 2025

      By Ozdavroz · Posted

      Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • bcozican
      WTAC 2025

      By bcozican · Posted

      i will be there 😁
    • patrickxdf12
      Squeaking clutch/throw out bearing

      By patrickxdf12 · Posted

      Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...