Jump to content
SAU Community

Recommended Posts

  • Replies 41
  • Created
  • Last Reply

Top Posters In This Topic

Swaybars changed my life, I'd get them straight up.

Spacers to give you extra lock cost <$50 so deff get those, makes the steering quicker too.

Coilovers are good too if your budget will allow. (BC Coilovers are good for around $1200)

Shim your stock diff up nice and tight.

500ml extra oil is handy.

Get an alignment too, ever so slight toe in on the back to help keep it predictable and slight toe out on the front to sharpen up the steering.

Tune Agent castor rods are cheap too ~$250, helps the car self steer. But I think adjustable castor rods are illegal for street use? correct me if I'm wrong.

Try and drift with brand new tyres, then you can spend more time out there and less time in the pits changing them thumbsup.gif

My car felt like two bricks connected by some playing cards before I got the cage put in it. While you wont actually damage your chassis by drifting (lol FF) some extra bracing might help tighten it up a little.

Before you do any mods though, just get out there and try it! See if you really like it first! Just give it a go ;)

Tyres... just buy tyres and get some track time.

Don't buy tune agent anything! I watched 2 pairs of castor arms break/fatigue topoint of failure with in 6 laps of a track!!!

Tyres, tyres, tyres...

Tyres... just buy tyres and get some track time.

Don't buy tune agent anything! I watched 2 pairs of castor arms break/fatigue topoint of failure with in 6 laps of a track!!!

Tyres, tyres, tyres...

My tune agent castor rods have done a lot more than 6 laps and I've had many unfriendly encounters with the curbs and they still look shmick as. I'll admit the older ones for the Silvias look like dried spaghetti though.

And yes, tyres, lots and lots of them. I've had good results with admirals. Cheap and they wear evenly right down to the carcass and don't delaminate at high temps. the Federal 595-ss are also good.

Get ready to buy HEAPS of tyres. :D Buy brand new ones though, 2nd hand ones you'll just spend the whole day in the pits swapping them over.

+1 to track time too, any track time is fine, even if it's not drifting, you just need to learn how your car behaves on the track\at the limit.

steering rack spacers are win and cost next to nothing

Spacers to give you extra lock cost <$50 so deff get those, makes the steering quicker too.

What are these,where do you get them, where do they go and how do they work..? :D

  • 2 weeks later...
  • 2 months later...

Where do you get those tierods that you posted simon?

You can get some Tien tierods from Cartel Aus - http://www.shop.cartel-aus.com/Tein-Tie-Rods-Tie-Rod-Ends-DWSS028.htm

I drift with just my stock 32, i just chucked in some tien coilovers and away i went, and it's handy to have good steer tyres. all the extra's just make drifting easier

  • 2 weeks later...

Diff... welded works a treat

choppies or coilovers if u can afford them... more drift less sailing on the high seas

Seat if your picky...

Fuel

Lots of tyres

A smile for the camera and the pretty ladies watching you

Seems people get so caught up on what is done to all the high end cars and forget to go out and give it a go.

I started in my first 32 years ago with a shimmed diff and a set of coilovers. best time of my life, spent plenty of money on fuel, entry fees and tyres then went and bought a seat and camber arms etc later on as I improved and found the need.

GO SKID

Edited by ti2l
  • 2 weeks later...

Alright,

I'm curious to see how a stock R32 reacts to sliding so I'll gradually add mods as needed.

This is how I think my priority list should look. I don't plan on buying everything at once or back-to-back so I'll see what the car tells me and upgrade as when I need to.

1) LSD - I'll probably get a 2-way diff as I'll use the GTS-T on the street and welds aren't daily driver friendly.

2) Sways- Adjustable only. I think Whiteline is the only company that makes adjustable sways for the Skyline.

3) Tie Rods - I'll be driving a '89 GTS-T so I'll probably buy whole replacement rods as opposed to just the spacers.

4) Harness (with stock seats) - Cassbo's suggestion. I'll try that first.

5)Clutch- A durable clutch

6) E-Brake- A durability to the E-brake (or upgrade)

7) Tires/Wheels- Brand New sticky tires up front and decent brand new tires for the rear. Extra wheels (maybe).

8) HICAS/ABS- Remove HICAS and/or ABS. I have my eyes on these: http://www.splparts.com/chassis-Z32.html#SPLHCKZ32

9) Suspension- Coilovers and supporting suspension parts.

10)Engine- PS cooler and more HP.

that's a mighty fine list you've got there son :)

Rack spacers should be on there too at #3.

Drift button too if you don't already have one.

Maybe a deep dish steering wheel too so you're not always slapping the wiper\indicators when you're throwing the wheel around. (that's if you have this problem)

  • 3 weeks later...

id be removing hicas sooner rather than later... will make life a lot easier

second hand tyres are fine for the rear... dont ned to be decent to get u started.. 595 or similar up front are cheap and work well

id also throw coilovers a bit higher up the list.... unless ur getting the angle grinder out ;)

u really wont need tie rods and rod ends till much later on, skidded for years in mine with stock tie rods etc.

stock handbrake is great... just get it adjusted

order should be:

Diff

Remove Hicas

Coilovers

skids

the rest can really happen whenever u progress and arent necessities to get you started..... stop thinking and go drive

yeah I've got the 595-evo on the front of mine, they're pretty good :) you want a slight stretch too to sharpen up the steering response. I upped my camber to -4 degrees too, changed my life.

Again, I have let the car tell me what needs to be changed..

This is a very wise attitude and I approve thumbsup.gif

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...