Jump to content
SAU Community

Recommended Posts

I just installed H1 8000K xenon headlights (lo-beams) and tested them out tonight. I didn't receive anyone flashing me or anything but when i walked out of the car and stood a few metres infront of it, i couldn't even see my car and was just blinded! When i'm driving down the motorways, all the signs light up from AGES away and it looks like i have high-beams on constantly.

Could anyone please help me out and let me know if it's normal, or how to adjust the intensity so it's a lot more... "mild" ??

I have a feeling that if i drive it around for a longer period of time, i'll get flashed, beeped at and maybe even pulled over by the cops cos it's too bright :\

Thanks!

Link to comment
https://www.sau.com.au/forums/topic/388047-hids-too-bright-help/
Share on other sites

You should have a little knob/switch with about 3 settings on the right hand side of the steering wheel near the bonnet release leaver, this dips/raises the lights.

That said, 8000k is very bright and dipping them probably wont help all that much, i believe 4700k or so is optimal for the best driver vision and minimal distraction to other drivers.

Wrong!

4700k are brighter than 8000k HIDs. Also you will find that 8000k have poor penetration in bad weather conditions.

The lower the Kelvin rating the high the Lumen (brightness) is.

Just lower the beam of your light enough so you dont get "as" blinded.

Wrong!

4700k are brighter than 8000k HIDs. Also you will find that 8000k have poor penetration in bad weather conditions.

The lower the Kelvin rating the high the Lumen (brightness) is.

Just lower the beam of your light enough so you dont get "as" blinded.

I was under the impression that the lower the K rating the less (glarey?) it would be for oncoming traffic? Lower K rating also means a more yellow/orange light and higher rating means a more Blue light? Although a more yellow light will penetrate better than the bluer type.

Am i close?

3000k Yellow

4500k White with yellow hue

5000k Pure White

6000k White with blue/purple hue

8000k White with distinct blue hue

10000k Strong blue light

Above that, you are getting into UV/black light territory.

For a street car anything above 6000k is pointless, 4500-5000k has the best light output vs penetration.

mine are similar, catches every piece of reflective tape/signage.

good to see the back of cop cars from far away.

and mine arnt set too high.

have travelled behind mates who havnt complaid, and when asked said it was ok.

i have LB 10000k 35w hid kit and the 100w 6000k kit for hb :) the 10k arent as bright but there ok and wen i do country driveing the 600k hids rape everything :)

also like sarge said the 10000k are really only good for looks there ok in the rain so i installed some driveing lights to counter them

It is my impression when I was researching them for my tow car & replacements for the KHR30, 4700k was Daylight, 6000k was Super White and anything past that was blue - purple the higher up the Kelvin scale you go and Kelvin is a temperature measure ONLY, nothing to do with brightness of a particular globe rating.

I have genuine Philips 6000K HID in my Jackaroo and cruising at night, Sydney ~ Melbourne & Sydney ~ Gold Coast they are without a doubt genuine 100kph plus lights on low beam and the high beam isn't much advantage over low. Better and more light with a good set of driving lights with good quality globes.

My advice is not buy sh!t ebay ex China/Hong Kong brands for $50 odd dollars. Their wiring kits & ballasts are sub standard and will often catch fire when your least expecting it & loosing the car is a very high possibility.

If they are blinding, lower the beam slightly until you find your not looking straight into the beam, irrespective of your globe choice, but adjusting to NSW RTA specs is absurd. A guide for me is when you're following another car about 20-30m behind and if your low beam isn't above the boot line, or bottom of rear windscreen they are adjusted properly enough to not distract.

JMHO

my lights in the 34 are idjustable :) took my Fn ariund to wire em in but they work a treat :thumbsup: i brought both my hid kits of ebay but yer you get wat you pay for my kits i didnt get any change from 160 '.' but they pay for them self being about to spot things along the road and police cars hi vis stand out like a DD boobies :rolleyes:

A lot of new cars these days come out with 6000k HID standard. Im pretty sure thats the legal limit aswell anything above that is illegal for low beam anyway and at own risk. I put 8000k in my 32 for LB, im not to concerned about the visibility issue as much, they work a treat and light up signs and centre line mint. I just hope i dont get caught pretty much.

They were pointing a little high like suwidji said, but i just adjusted the bulbs down and now they dont flash on coming cars. There is typically 2 or 3 screws in the headlight cases behing the headlight you tweak to adjust the bulb direction. Have a play around, its an easy fix.

From what ive read, Nytsky is right, 4500 to 5000k is the best viewing performance range. I think higher like 6000k 8000k you see signs etc better.

just one thing unless ur car has projection HID's there not legal also it must have wipers because water will trow the light , its all bull shut but thats how they will get ya ,, as projection hid's have a very sharp cut off line to stop the dazzle youtube it to see wat i mean :thumbsup:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm selling my personal race car. 1992 BNR32 Skyline GT-R About eight years ago the engine developed the dreaded low oil pressure problem. I removed it and found the issue. However shortly after I moved half way across the country, moved my work shop, bought a house, got married, then moved my shop again to it's permanent location for the time being. in turn I do not have the time to race this car as it should be. In turn the engine I built for this car will end up in my street car and this car I hope finds a home with someone who can use it to it's full potential. The roll bar was built by Jason Noren Fabricaiton in Pomona California to SCCA and NASA Specs. The car used to compete in redline time attack and global time attack enthusiast class. It also has a fire suppression system.  The car is with me at my workshop in Kyle Texas, USA. Shipping it is no problem, I can personally deliver the car to the port of either Houston or Los Angeles. Any other port depending on where it is may require transport but we can always work that out.   The chassis itself is rust free, rear quarters and under fenders are free of any rust so it's a very solid foundation for anyone who wishes to move forward with it. As posted and at the asking price of $20,000 USD the car includes all of the following;   All OEM Body panels, front fenders, rear bumpers etc.  OEM Nissan Projector headlamps (Pictured N1 lamps were removed) OEM Nismo Side Skirts / Extensions OEM Rear Spats  Front & Rear Subframes are installed car is full roller Rear Subframe has Cusco Camber Arms, Whiteline HICAS Elimination Front Subframe has Whiteline tension rods and whiteline Sway bars w/ endlinks.  Buddy Club N1 Coilovers All chassis wiring and engine wiring is in tact. Attessa System is fully in tact and was functional before engine removal.  BCNR33 GT-R Brembo Brakes F+R with Endless MX72 Plus Pads, DBA Rotors & Stainless Steel Brake lines Billion Racing Radiator Billion Radiator Hoses Fluidyne Engine Oil Cooler Accusump System (trunk Mounted) 5 Speed Transmission w/ Transfer Case F+R Prop-shafts Rear Differential With rear Axles.  Nismo Gauge Cluster Nismo Clutch + Flywheel   Essentially what is needed to make this car running and driving again is as follows: A working Engine, an ECU, and time to put it together. The price posted is or best offer as I am willing to remove some components to accommodate price to a certain extent. If any serious buyer wants full detailed pictures, videos, or any questions I'll be happy to answer them. I believe this car is priced to move quickly considering it's a rust free and very straight chassis but always open to fair negotiation.  I can be contacted via phone or email. (+19517081648) email is [email protected]   
    • So...to my (and my mechanics doing the swap) surprise...the oil pan from NEO engine does not fit 100% and needs to by modified like this: It is not a huge problem but in the future i want a "proper" oil pan. So question is...what different oil pan can i get to fit without any problems and modification? Thanks! 
    • Some more info I found.  These are the last entries Yoshikiyo Fujii made on his blog before he passed away in 2009: http://blog.livedoor.jp/fujii_dynamics/ And finally this is where the workshop was situated:  https://maps.app.goo.gl/HhTPtHzt3WVcBTiEA  
    • shit boxes, kids, and daily drivers are all welcome
    • Cam seals go hard. It's a very old car.
×
×
  • Create New...