Jump to content
SAU Community

Recommended Posts

  • Replies 177
  • Created
  • Last Reply

Top Posters In This Topic

BTW, youj can fit a bigger filter if you want. The flat surface the filter mates onto is quite large. Just get one with same thread & bigger body & it will work OK.

Might want to check to make sure you can drive a VQ35de Stagea.

Can't legally drive a VQ35de Skyline in Vic and NSW, so maybe SA have followed suit?

VQ35 Stagea should be fine, over here the regulations are

High-powered vehicles

A high powered vehicle is a light vehicle with a Gross Vehicle Mass of less than 4500 kgs that has:

  • 8 or more cylinders
  • a turbocharged or supercharged engines(except diesel powered vehicles with less than 8 cylinders)
  • been modified to increase engine performance (link to vehicle modifications section below)
  • been nominated high performance vehicles - refer to the list of Included Vehicles in the High-powered vehicles notice below.

And the high powered list doesnt mention the VQ Skylines thumbsup.gif

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Possibly avoid using a Cometic one unless the deck/head surface are perfectly flat. I did have a look just then and forgiving gaskets such as Tomei or Nitto don't exist for the FJ20, however the Bar-Tek or Kameari ones look good and might do the trick.
    • Because pipe threads for pipe things. M threads for bolt things. Throw some teflon sealant onto it and dust your hands off knowing you did the right thing, instead of going twice around the block to achieve a result using the wrong things. Of course, all of these solutions are ignoring the fact that the minimum thread pitch we're talking about here is 1.25mm, with the 1/4" in NPT or BPS being out around 1.4mm. You will need to know that the boss you're tapping has enough thickness for at least a few threads. That's one of the reasons that 1/8" is commonly used - because the pitch is <1mm. And why would you look to use 1/4" NPT in a BSP country anyway? Ugh.
    • Just throwing around ideas, does it need to be in the compressor cover? Why not the hot side piping?
    • 1/8NPT drill size = 8.7mm. Since the hole got messed up by me, it’s probably around 9mm.    So 1/4” NPT would be next step. A drill size of around 11mm would be preferred there which is not way of my M12 (drill 10.5mm and tap M12 threads) 
    • 3 Kids are starting to hit that ages. I wanted to get them something special to learn on, put down the screens and have some fun. 4Door 2001 R34DE Black Pearl GV1 Jap Import, AU 2nd owner. Pre Work done. Suspension - Wheels Pedders SportsRyder Coilovers   Wheels TSG Spokey Boi 18'x9.5"+15 Body JASI Aero 4 door Type R Full Kit LED Conversion - Parker, Blinkers, & Reverse Exhaust Hurricane Headers 100 CPI high flow cat 2.5" Piping Cannon muffler Internal Bride low max stradia ii - front seats  Bride RO seat base and Rails (R/H) Cube short shifter LED Conversion - Interior   
×
×
  • Create New...