Jump to content
SAU Community

Recommended Posts

pffft Tats will be disappointed... and so will I!

FWIW it's not about perfect cars, just give it a Carlovers once over and it will be fine :P

You should see mine!

Hey shell, yea sorry about that.. :( Might still come along to have a look, but has been a long week for me. Car needs a service badly, n I haven't had the time to do anything with it lately. Hopefully once my new shed is built, I'll be able to get some stuff done at night ;)

So yea, I'll still see you there!

  • Replies 146
  • Created
  • Last Reply

Top Posters In This Topic

See you all around 8am, I washed my car, but didn't clean the inside lol whistling.gif it'll be fine, no one will look at it

Cejay, my paint isn't very good either so don't stress! Although it looks better now then it does in my signature

We will meet beforehand at the usual Friday night location - Grevillea Park (just past the Boathouse restaurant).Be there at (or before) 9am and we can drive down together.

The guy told me he'd like us all in by 10am-ish

Meet 9am

Leave 9.15am

Grevillia Park

I polished half my car.. yeah baby EFFORT

see you in the AM

ps. unlike other years - NO DOGS.. was going to bring the Molly dog down but he said the horses might not appreciate it

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...