Jump to content
SAU Community

Recommended Posts

  • Replies 106
  • Created
  • Last Reply

Top Posters In This Topic

So much vitriol over such a non issue....:P

The only way to definitively compare one car to another is to have them at the same spec/mod level. It's pointless saying "my Paseo will whip your S-coupe!" (or for Ghostrider "my Renault Dauphine will whip your Karmann Ghia!" :) ) unless both are totally stock or both have identical mods.

John's car is not a Zed, but a heavily modifed version of one. Line up a stock Z32 against a stock R33 and you have a relevant starting point.

NAILING A ZED!

Merli,

Can we stop hurling abuse at each other and talk fact.

Your NEGATIVE & subsequent dick swinging & impressing 14 year old girls comments, set the mood for my posts.

I have since been advised that your motivation was the defence of a mate.

It has also been established by some! that I may not fit into the generalised category of MOST on this forum and for the exercise, let's just consider me an equal to John's driving experience and talent.

John boasts that his Z32 has 345 rwkw, but his approx weight is 1640 kg with a drag coefficient of 0.32.

If you take a Skyline weighing approx 1215 kg, a drag coefficient of 0.37, it is 35% lighter with a similar drag coefficient and therefore only needs 225 rwkw to do the same task.

If the lighter Skyline has similar or better brakes, and about 245 rwkw and has an equal driver, it is VERY likely that it will lap consistently quicker than the Z32, at least on paper.

Hence my comment on it not needing a GTR to beat a Zed

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Power steering is probably because someone has nuked the HICAS CU and you no longer have the variable power asist doing what it is supposed to. How much boost are you running? You are aware that any more than 10 psi on the stock ECU is just asking for it to go to full R&R (that's Rich & Retard, which is effectively Retarded and Retarded!) which kills all the power. Depending on the exact conditions, it can just be runnign on the fat and stupid end of the maps, then the conditions change, you make a little more boost and the ECU goes into panic.
    • @BuiltNotBought Just as GTSboy said.   If you want driveabilty and more low down torque..keep the stock runners. They are VERY good from a factory. I have them too on my RB25DET NEO and as a GTSboy i have fmic but with stock piping route(i have Blitz intercooler) Iam making around 320 BHP and the car pulls "hard" from like 2,5k all the way to 7k. I have it dyno tuned to mimic N/A power curve and making little less max torque due to the smallbox tranny. But driveability is very great. I had 350Nm below 3k so car feels very quick.
    • Looking to sort out a couple of issues on my skyline  It recently was rebuilt, however rebuilder long story short did not give two flying effs about the work he did. So moving forward it's running but I have two persistent issues 1) it has a misfire / lag type of issue (was at higher RPMs but I had a dead piggy back ecu removed which improved it) now it's not as bad but still does it at random, I thought it may have been a boost issue I'm running an older turbosmart dual stage controller, turbosmart told me to try running off gate pressure however it still has a lag at random times. It has New MAF, maf plug, coil packs, sparks, CP harness.. injectors tested and cleaned. Factory ECU. 2) Power steering issue. It is tight as anything. Flushed power steering, rebuilt my pump because the bearing was shot. Flushed again still tight (mainly when parking and going slow into my driveway etc)  No kinks in hard lines, replaced the lines I could see had cracks. Still tough to steer.  I was told to shim a coin and place into the solenoid plug? Is there anything else. My steering angle sensor also has a issue. It's a used one I replaced, does it need to be calibrated? I feel like I've tried everything and this car is my voodoo doll.   
    • Holy shit... wow!!! I totally missed this
    • One main filter. Each tank has a prefilter to keep rocks and small children out, then the big main filter that also does water separation. Clogged the first one so bad it was like a rev limiter at 3200rpm. Literally just like dropping the throttle off and maintaining rpm!
×
×
  • Create New...