Jump to content
SAU Community

Recommended Posts

The car is a 1994 R33 GTST (series 1) (located in the ACT)

I have owned this car since late 2006 as my daily driver, in that time it has gone from having nothing more than a pod filter and a cat back exhaust to what it is now.

The car has been regularly serviced in the time i have had it, and as of right now the engine has around 6-7000km since it was refreshed (Late July 2011 (by Proengines) and was initially built in august 2009 (by proengines) after the stock RB25 spun a big end bearing).

The car has ACT rego until Nov 2012

The car has been engineered for the RB25/30 conversion including all engine mods and aftermarket suspension (with full emissions testing you do not need to modify the engine in any way for rego)

The paint and bodykit are completely standard except a copy GTR rear wing and light up "SKYLINE" fascia above the rear bumper.

I have receipts for most of the parts or work done to the car including dyno sheets over time as it has been built up from its stock 130kw to its current 394kw

Mods list (i have probably forgotten a few):

Engine:

RB30 series 2 Block

R33 RB25DET head

Forged pistons (Arias 9.3:1 CR, oversize 86.5mm bore)

Cometic MLS 1.3mm Head gasket

Forged rods (Eagle with ARP bolts)

Grub screwed stock crank

Pro Engines extended oil pump drive

RB26 standard water pump

RB26 N1 Oil pump

External oil feed for VCT using T piece at the oil pressure sensor.

ARP main studs

ARP head studs

ETM high mount exhaust manifold

Synchronic 50mm external waste gate (plumbed back into exhaust but could be modified to a screamer without much effort)

ETM 4" Dump pipe

3.5" front pipe

Modified Apexi N1 3.5" cat back exhaust (this should pass RTA noise tests)

3.5” in/out 5” body 100cpi Vemom cat (i also have a 2.5" euro 3 emissions cat you can have if you want)

Garrett GT3582R 0.82 AR rear housing

Greddy Intake Plenum (genuine not a cheap ebay copy)

Q45 90mm Throttle body

600x300x100 intercooler (3" inlet and outlet)

3" mandrel bent intercooler piping

Alloy 52mm radiator

16" thermo fan ECU controlled

Balanced pistons, rods, crank, flywheel. (to within 0.1 gram)

ACL conrod bearings

ACL main bearings

Stock cams with VCT retained

NGK Copper spark plugs (0.6mm gap)

Yellow Jacket coil packs (also have stock coils spare)

Air-conditioning has been removed however i have all the parts in a box

Fuel System:

Nismo 740cc injectors

Bosch 044 fuel pump mounted in tank

Stock fuel feed and return lines

Stock fuel pressure regulator

Electronics:

Vi-PEC V66 Plug-in ecu (Map based, with 4BAR map sensor)

boost controled by ECU + solenoid (currently running 26psi)

Techedge wideband O2 sensor/gauge (hooks into the ecu for wideband o2 control)

Snow performance stage 2 Water Meth injection kit (currently running 51%/49% water/meth (turns on at 8 psi, full flow at 25 psi))

Drivetrain:

NISMO LMGT2 wheels 17x8 with 235/45/17 near new Federal 595 RS-R tyres on the front, 17x9 with 255/40/17 near new Federal 595 RS-R tyres on the rear (all 4 tyres replaced early feb)

Tien HA coilovers (includes height adjustment spanners)

Standard calipers, with slotted disks all round, EBC Yellow pads on the front and EBC Red pads on the rear

JJR Adjustable upper arms front and rear

Hicas Lockbar

Jim Berry full monty clutch

Gearbox rebuilt with new bearings, seals and synchros in 2009 as the 5th gear syncho was failing.

Diff has had 4mm total worth of shims installed, it acts like a locked diff currently.

Cars bad points:

Paint in general is not fantastic

Has had a couple of small bumps over the years (no crashes)

There is a small oil leak that had recently developed (few drops after driving)

Drivers seat does have a tear in the fabric

The car is currently making either a clutch or gearbox noise at idle, this does not affect how it drives but have been advised not to drive it until the gearbox/clutch can be removed and checked out properly, as such it is not currently being driven. - Fixed

Looking for offers of $23k or $20k if you want to take it as is (no silly offers people this car has had a lot more than that spent on it and is stupidly fast for the money)

The only cars i would be interested in swaps for are: BF XR6 turbo or Nissan Stagea 260RS

NO TEST PILOTS, test drives are for serious buyers only, this car is not a toy.

Anything else please PM or call/sms 0419302418

post-32350-0-85201000-1332140393_thumb.jpg post-32350-0-51605900-1332140403_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/395232-394kw-1994-r33-gtst-act/
Share on other sites

couple things i have realised i forgot to list in the original.

it has an ASR 6.5L baffled/gated sump and aftermarket valve springs.

it has a side head oil drain and and extra oil return fittings welded to the sump (everything that returns oil to the sump has its own fitting, no T pieces or Y joins)

Has adjustable upper arms front and rear

Stereo setup, Eclipse head unit (fairly standard cd/mp3 support), 4x mids, 4x tweeters, 1x 12" metal cone elcipse sub in custom fiberglass box (running off a 760w RMS amp)

The water meth setup has a boot mounted 9.5L tank (this is enough to do quite a few laps on most tracks before you will run into surge issues (gravity feed into the pump))

few more pictures

Light up "skyline" logo on the rear

post-32350-0-93268800-1333175934_thumb.jpg post-32350-0-76825700-1333175989_thumb.jpg

Water meth setup in the boot

post-32350-0-06469400-1333175947_thumb.jpg post-32350-0-97406800-1333175959_thumb.jpg

Sub/amp setup

post-32350-0-82155500-1333175982_thumb.jpg

Block with the head off a few years ago.

post-32350-0-52343200-1333176310_thumb.jpg

The car is currently making either a clutch or gearbox noise at idle, this does not affect how it drives but have been advised not to drive it until the gearbox/clutch can be removed and checked out properly, as such it is not currently being driven.

This issue has now been fixed.

  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 3 weeks later...
  • 2 weeks later...
  • 2 weeks later...
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The fancy pants red shock tower brace is finally incoming from MX5 Mania, getting it shipped from 'Merica has been a long and problematic process, and GWR, the 'Merican supplier will not ship directly to consumers outside of the US, Mania basically had to order a heap of them, the colour choice was silver, or red, and we all know anything red adds 5 killerwasps of dynotorques..... Whilst it does fit over a 2.5, and I've seen a few photos and videos of it being installed and fitting, google also says it might get real close to the FAB9 intake front runner, people in the US says it does fit with the FAB9 intake, except for one person who said it slightly touched.......so there is that.....LOL..... As it seems that I am the first in AU to have this combination of parts there's no local knowledge about fitment, so I'm just a willing guinea pig in this endeavour, I'll cross my fingers and toes and hope for the best In other news, I ordered stuff from China  on the same day I ordered the 23° silicone bend from Victoria, the stuff from China arrived a day ago, the 23° silicone bend is still travelling around Australia thanks to Australia Post, and "may" be here next week
    • Very good news...I contacted Racebox about it last night. My car is a 2016 so remains to be seen if it is compatible, requires a TCU swap, or is impossible.
    • What ECU are you running? This is probably the biggest question. If it's a PowerFC, I'd probably change the ECU and get something newer that will handle the injectors in a nicer way.
    • FYI: Racebox RE7R Custom Tunes Released!   https://goracebox.com/.../2017-infiniti-q50-q60-re7r-tcm...   FOR GEN 2 (21+) VEHICLES, PLEASE SEE NOTE AT BOTTOM See more   But whomever tuned your car is the tuner you should go back to, AMS, Sonictune or BT Tune....
×
×
  • Create New...