Jump to content
SAU Community

Recommended Posts

The Bosch 044 I just found out was a 700hp pump which is hell good enough I'm

Not sure what pump I have I bet it's a standard gtst pump running a rb26 I got the car like that I can hear the pump dying in the ass when u let it prime up with the ignition on u can get Bosch 044 rip offs for 70 buck eBay bloke reckons he runs them in his race car but there 100 less lph then the real thing not sure if I trust copy's of the Bosch 044

  • Replies 66
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Lol at copies, as if you even consider that espicially for something crucial like a fuel pump which youve just leRnt the hard way.

If you can afford 500 go nismo its direct fit 10 min install but if you want to save abit go the 044 for 200 bux just have to muck around a little to make it fit in stock position.

Yeah but the thing is I don't know if it was my fuel pump or why waste money if I don't know all I no is that it was melting the outsides of the pistons it's was running then just stalled like out of fuel lost compression and little bits of steel shavings where in the bores from the tops of the outsides of melted pistons

I have new motor

So as Jez said; put it in, drive it sedately to a tuner, and get them to check everything out.

You could also just pull your fuel pump out and check what it is, takes 10 minutes. If it's a stock GTST pump then you can be fairly certain that's what the issue was.

Im going a genuine 044 Bosch yeah I'm not sure close to 500 I think but I bOught the car like that next thing it's starts detonating when being thrashed cracks a ring land ok then new piston and rings where put in then it stalls and loses compression

I have a standard rb26 boosted up to 14psi with a full exhaust and pods that's all mate

Im going a genuine 044 Bosch yeah I'm not sure close to 500 I think but I bOught the car like that next thing it's starts detonating when being thrashed cracks a ring land ok then new piston and rings where put in then it stalls and loses compression

500hp with a standard 26 with a bit of boost? You have no idea what you're talking about do you lol?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...