Jump to content
SAU Community

Sau Vic 2012 Motorsport Championship Round 5 - Sandown 11Th August


Recommended Posts

lol it such a hack track compared to PI..

This is the bit I hear all about gets me worried...watch from 1 minute

that's Roy a SAU member.

he was leaking Gearbox oil I belive (could be engine)

so the rears were coated with oil when he went to turn in.

so assuming your not planning on pouring oil on tyres prior to going out you should be fine.

  • Replies 307
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

I went off turn one forgetting to brake lol

looks like i wont be partikipating here :( way too much needs to be done to get it on the track

allignment

touch up tune

tow

cams

membership renewal(will happen anyway)

but i doubt all will be done before the 11th lol

Edited by Sunkist

looks like i wont be partikipating here :( way too much needs to be done to get it on the track

Scared bud?

Just get it all done, you will need it for the next track day. Why else are you powering the car up, you can't use it on the street...

Scared bud?

Just get it all done, you will need it for the next track day. Why else are you powering the car up, you can't use it on the street...

i am getting it all done. but traction tyres cant have me in till next week because i need to flare the guards some more.. and thats only if i have time then.

all happening. not as soon as i thought it would though.

Can we sign up for cams on the day or has to be done before hand...don't think there would be enough time for it to be processed by mail.

There is a tear off slip down the bottom of the application which you can use on the day.

An SAU VIC representative will have to sign it. As Richo won't be there I'm assuming Martin or myself can sign it?

Good to see another first timer will be out with me! :D

Or even an email. I sent mine in with an attached Facebook picture as the photo as I didn't have anything else lol

Was processed and sent out within a few hours :thumbsup:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...