Jump to content
SAU Community

Recommended Posts

Ok dudes i know i have some sort of issue with the car missing at around 4-5000rpm, which after much messin around we figure its gong to be coil packs.

We ran my car up on the dyno at my mates wshop on the weekend and ony made 134rwhp this was just over 4000 rpm

the car is r33 4door

rb25det

iridiums at 0.8

knn filter

full 3" although cat isn't hi-flowed

bleed valve standard boost ( we changed the boost in increments from 7-10psi and onlly made 2-7 hp difference

this was extremely concerning as it only put out about as much as my 900kg datto which is still pathetic.

any one else seen these types of figures.

I know there is nothing wrong with the dyno as it is the one from the recent summernats hp heroes the one that ran 1470rwhp on it, apparently most accurate in oz. i will have to tune next week but i wouldnt think that coil packs would make that much difference would they we should expect arount 200-210rwhp

comments thoughts

Link to comment
https://www.sau.com.au/forums/topic/40620-concerned-about-dyno-hp/
Share on other sites

yeh i know would coil packs rob me of that much power, the air fuel ratio was cool, the curve looked ok then bang straight back down at around 4000-5000, which is where my misfiring is, hmmmmmm, i have found that it only seems to happen under heavy load, ieif i run the accelerator easing it on lightly all the way to redline, it seems to pull the right way, but if just plant my foot nothin after the 4ish you just get the missing,

sounds like car has similar mods as mine not to sure if yours is full 3" is turbs back, butwe did notice that the standard cooler is crap as we were spraying water on it and was just drying so quickly, fmic would be handy, even yours to mine 134 to 170 is a big diff!!

we could have taken it higher but it wasnt making any power past 4000rpm

That power at those particular revs sounds about right. But you should continue to make power til about 6400, or even more with your mods eg exhaust. Peak power arrives t 6400 on a standard car. hopefully its just the coil packs.

I would think if a coil pack works ok at light load, it should also work ok at full load. Not 100% on this, but you could prolly use an Insulation Resistance tester (megga) on the 1000v scale to test it (know any sparkies?). The primary winding should have continuity from one end to the other and should not be shorted to earth. I think the secondary should also have continuity from the plug top to earth on the coil pack. Please correct me if i'm way off the mark!

rb25 you would think that yours and mine should be making more power, they are around 180-190 standard from factory?

there is wear and tear but we had an older supra on there similar mods 4 years older no rebuild more kms and put out 200rwhp and they come out with 187kw factory same as skyzers i think?

similiar problem to my tuning at CRD. Mine's FMIC, unichip, full exhaust, EBC

made 163rwkw with a stuffed coil pack, replaced it and made 181rwkw on 7psi.

Jim @CRD suggested gapping the plugs from 0.8 to 0.75 if wanted to go on higher boost as the spark was breaking down with more than 7psi. Gapped it and had a test run on .8(11psi) and .9(13psi)bar, sweet.....

I had this problem on my car....the engine was misfiring and spark was breaking down at high RPM (4000 or above). Had the workshop check it out and found that 2 of my coil packs were on the way out. I bought 2 second hand replacements from the for sale section on SAU replaced the old ones and now everything is sweet. In the meantime while running with the faulty coils the workshop regapped the corresponding spark plugs closer in order to try and reduce the misfiring. As more load is put on the coils, the spark breaks down more and arcs out causing the misfire. Check your plugs as well because there could be a lot of deposit on them which may be fouling them as well.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...