Jump to content
SAU Community

Recommended Posts

Ok dudes i know i have some sort of issue with the car missing at around 4-5000rpm, which after much messin around we figure its gong to be coil packs.

We ran my car up on the dyno at my mates wshop on the weekend and ony made 134rwhp this was just over 4000 rpm

the car is r33 4door

rb25det

iridiums at 0.8

knn filter

full 3" although cat isn't hi-flowed

bleed valve standard boost ( we changed the boost in increments from 7-10psi and onlly made 2-7 hp difference

this was extremely concerning as it only put out about as much as my 900kg datto which is still pathetic.

any one else seen these types of figures.

I know there is nothing wrong with the dyno as it is the one from the recent summernats hp heroes the one that ran 1470rwhp on it, apparently most accurate in oz. i will have to tune next week but i wouldnt think that coil packs would make that much difference would they we should expect arount 200-210rwhp

comments thoughts

Link to comment
https://www.sau.com.au/forums/topic/40620-concerned-about-dyno-hp/
Share on other sites

yeh i know would coil packs rob me of that much power, the air fuel ratio was cool, the curve looked ok then bang straight back down at around 4000-5000, which is where my misfiring is, hmmmmmm, i have found that it only seems to happen under heavy load, ieif i run the accelerator easing it on lightly all the way to redline, it seems to pull the right way, but if just plant my foot nothin after the 4ish you just get the missing,

sounds like car has similar mods as mine not to sure if yours is full 3" is turbs back, butwe did notice that the standard cooler is crap as we were spraying water on it and was just drying so quickly, fmic would be handy, even yours to mine 134 to 170 is a big diff!!

we could have taken it higher but it wasnt making any power past 4000rpm

That power at those particular revs sounds about right. But you should continue to make power til about 6400, or even more with your mods eg exhaust. Peak power arrives t 6400 on a standard car. hopefully its just the coil packs.

I would think if a coil pack works ok at light load, it should also work ok at full load. Not 100% on this, but you could prolly use an Insulation Resistance tester (megga) on the 1000v scale to test it (know any sparkies?). The primary winding should have continuity from one end to the other and should not be shorted to earth. I think the secondary should also have continuity from the plug top to earth on the coil pack. Please correct me if i'm way off the mark!

rb25 you would think that yours and mine should be making more power, they are around 180-190 standard from factory?

there is wear and tear but we had an older supra on there similar mods 4 years older no rebuild more kms and put out 200rwhp and they come out with 187kw factory same as skyzers i think?

similiar problem to my tuning at CRD. Mine's FMIC, unichip, full exhaust, EBC

made 163rwkw with a stuffed coil pack, replaced it and made 181rwkw on 7psi.

Jim @CRD suggested gapping the plugs from 0.8 to 0.75 if wanted to go on higher boost as the spark was breaking down with more than 7psi. Gapped it and had a test run on .8(11psi) and .9(13psi)bar, sweet.....

I had this problem on my car....the engine was misfiring and spark was breaking down at high RPM (4000 or above). Had the workshop check it out and found that 2 of my coil packs were on the way out. I bought 2 second hand replacements from the for sale section on SAU replaced the old ones and now everything is sweet. In the meantime while running with the faulty coils the workshop regapped the corresponding spark plugs closer in order to try and reduce the misfiring. As more load is put on the coils, the spark breaks down more and arcs out causing the misfire. Check your plugs as well because there could be a lot of deposit on them which may be fouling them as well.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Drain it. I got official Matic D but you can get whatever is listed as Matic D compatible.
    • Thanks guys,  Yeah I should at least have them dynoed, at least then I know what I've got as a starting point.  The springs on these are hard as rocks. I vaguely remember Russman saying he was going to sell the shocks to me with the rocks fitted, as he was keeping the softer springs for his new setup.  I didn't click at the time but of course that was to let me know the shock/spring wouldn't be matched.  I also remember pricing up new springs around 2014-15, but, house, money etc. it never happened. So that was another reason to have them rebuilt. I have rebuilt the forks on many motorcycles so I think I could handle the seals on these easily enough, but getting the valving right would be a rabbit hole I cbf exploring.  Duncan, interesting to hear RP was tuning these back then. I might give them a call.  In the mean time I have been busy fitting sway bars. The Whiteline rear sway bar I purchased 15 years ago finally got fitted, along with the Whiteline front bar that showed up last week. Just waiting on new links for the front sway bar to finish that off.  And my spare set of advan AVS VS5's should be back from the powder coaters in a Pearl White finish sometime this week, with a set of Hankook RS4's lined up for fitting.  And then I just have all the suspension bushes to do. A comprehensive kit is on the way... Lots to do before the Ararat hill climb. Cheers guys 🍻   
    • Nice car! I’m glad folks in the US have gotten past the FnF and are buying real cool cars like the 260RS I was with a bunch of mates in Portland about a year ago and spotted a green Stagea (just a regular 2.5T AWD) parked about 2 blocks away and they were like “a what?” So I made a bet with them for a round of beers and said “ok one of you run down there and tell me if the steering wheel is on the correct side” 5 mins later the American comes trudging back up the hill and goes “he’s right guys. Ok what beer do you want?”
    • Should replace OR drop the tank, give it's good clean. Might be worth replacing that entire fuel level/pump/cradle thing with this: https://frenchysperformancegarage.com/products/fpg-s13-180sx-r32gtst-single-pump-hanger-kit-billet-hat-6-v3-fpg-089?gQT=2  
    • Thank you so much for the help
×
×
  • Create New...