Jump to content
SAU Community

Recommended Posts

  • Replies 73
  • Created
  • Last Reply

Top Posters In This Topic

I am like sooooo one step ahead of you :rofl:

LW.

Actually, I am one step ahead of you :) My car is already here :P

Unfortunately, it has been stuck on the docks for over 2 months. :( Even worse, it's not even in NSW. I hope it hasn't been stripped. Thankfully, my other set of mags didn't get put with that car.

Guest two.06l

Silver 93 r32 gtr import

Engine

· Micks Metalcraft 4” Intercooler

· Dual Blitz blow-off valve

· Top Secret Super radiator, Trust hi psi cap

· External 19 row oil cooler with thermostat

& remote filter (not fitted for D.C.)

· Trust clear timing cover

· Trust timing belt (new tension pulleys)

· HKS vernier cam gears

· Nismo valve stem seals & bronze guides

· Knife edged and ported head

· Tomei 260 degree camshafts

· Tomei 1.2mm head gasket

· Tomei oil restrictor kit

· Tomei sump baffle kit

· N1 oil pump & water pump

· Cryogenic treated, crack tested & linished crank

· Cryogenic treated, crack tested, shot peened,

resized, closed & honed polished conrods

· ARP rod bolts & head studs

· Cryogenic treated Aries forged pistons

with teflon coated shirts

· Total seal gapless rings

· Deburred, honed & crack tested block

· Clevitte 77 main & rod bearings

· HKS 2530turbos with HPC coated

turbine housings

· HKS manifolds, HPC coated

· HKS dump pipes with separate

wastegate HPC coated.

· HKS adjustable waste gate actuators

· Tuned length engine pipes

· HKS dunk megaphone 3” exhaust

· HKS piping kit (turbos to plenum)

· 80mm Z32 airflow meters

· HKS super power flow filters

· Sard 720cc injectors

· Trust fuel rail (twin inlet)

· Sard fuel pressure regulator

· Twin Bosch motor sport fuel pumps

· Performance MetalCraft surge tank

· 500hp Bosch swimmer lift pump (in tank)

· Custom alloy catch tank

· Nismo engine mounts

. Splitfire ignition coils

Suspension and Brakes

· Cusco master cylinder brace

· Cusco front strut brace

· Cusco rear strut brace

· Auto Select A pillar braces

· Endless brake pads

· HKS hyper damper coil overs

· JIC rear upper link arms

· UAS front upper link arms

· Rear subframe bushes

· UAS 330mm front brake rotors (not fitted for D.C.)

Electronics

· Apexi Power FC computer

· Apexi AVC-R boost controller

· Apexi turbo timer

· Carel inlet temp meter

· 300km speedo

· Auto meter 0-35 psi boost guage

Driveline

· Jim Berry modified clutch set-up

· Nismo lightened flywheel

· Exedy super single clutch plate

· Nismo 4800 pound pressure plate

· Rebuilt Nissan GTR gearbox with Cryogenic treated internals

· Nismo gearbox mounts

· Falken Azeni tyres

· 17x8 front & 17x9 rear Super Tourer alloy rims

Owner/Driver:

· Stacey Diemar

Research / Development / Tuning:

· Dirt Garage Crew: Paul, Darren, Luke, Duncan, Peter, Patrick

· DP’S Motorsport

· Croydon Racing Developments

Sponsors:

· Wanted,

Silver 93 r32 gtr import        

Engine

· Micks Metalcraft 4” Intercooler

· Dual Blitz blow-off valve

· Top Secret Super radiator, Trust hi psi cap

· External 19 row oil cooler with thermostat

& remote filter (not fitted for D.C.)

· Trust clear timing cover

· Trust timing belt  (new tension pulleys)

· HKS vernier cam gears

· Nismo valve stem seals & bronze guides

· Knife edged and ported head

· Tomei 260 degree camshafts

· Tomei 1.2mm head gasket

· Tomei oil restrictor kit

· Tomei sump baffle kit

· N1 oil pump & water pump

· Cryogenic treated, crack tested & linished crank

· Cryogenic treated, crack tested, shot peened,

resized, closed & honed polished conrods

· ARP rod bolts & head studs

· Cryogenic treated Aries forged pistons  

with teflon coated shirts

· Total seal gapless rings

· Deburred, honed & crack tested block

· Clevitte 77 main & rod bearings

· HKS 2530turbos with HPC coated  

turbine housings

· HKS manifolds, HPC coated

· HKS dump pipes with separate  

wastegate HPC coated.

· HKS adjustable waste gate actuators

· Tuned length engine pipes

· HKS dunk megaphone 3” exhaust

· HKS piping kit (turbos to plenum)

· 80mm Z32 airflow meters

· HKS super power flow filters

· Sard 720cc injectors

· Trust fuel rail (twin inlet)

· Sard fuel pressure regulator

· Twin Bosch motor sport fuel pumps

· Performance MetalCraft surge tank

· 500hp Bosch swimmer lift pump (in tank)

· Custom alloy catch tank

· Nismo engine mounts

.               Splitfire ignition coils

Suspension and Brakes

· Cusco master cylinder brace

· Cusco front strut brace

· Cusco rear strut brace

· Auto Select A pillar braces

· Endless brake pads

· HKS hyper damper coil overs

· JIC rear upper link arms

· UAS front upper link arms

· Rear subframe bushes

· UAS 330mm front brake rotors (not fitted for D.C.)

Electronics

· Apexi Power FC computer

· Apexi AVC-R boost controller

· Apexi turbo timer

· Carel inlet temp meter

· 300km speedo

· Auto meter 0-35 psi boost guage

Driveline

· Jim Berry modified clutch set-up

· Nismo lightened flywheel

· Exedy super single clutch plate

· Nismo 4800 pound pressure plate

· Rebuilt Nissan GTR gearbox with Cryogenic treated internals

· Nismo gearbox mounts

· Falken Azeni tyres

· 17x8 front & 17x9 rear Super Tourer alloy rims

Owner/Driver:  

· Stacey Diemar

Research / Development / Tuning:  

· Dirt Garage Crew: Paul, Darren, Luke, Duncan, Peter, Patrick  

· DP’S Motorsport

· Croydon Racing Developments

Sponsors:

· Wanted,

Nice setup there stacey!

Merli,

Not yet, have not had the car 100% since PAS when it got the 421hp. But now with new twin plate clutch, fixing the knock problems and a new front cv I hope to get down to the plex when racing starts again.. Though I have no illusions to my crappy driving abilities, I'd hope to get into the 11's with that power figure...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • A few small updates since the previous post and lessons. I decided to do a little interior light upgrade on the 110. I quite like the iilumo items, even if they're a bit of a premium over other brands. You'll also note the Stedi Fogs, that will go into the S15 fog lights as I needed to match the bulbs since I got the new ones earlier. I hope they fit as the body is quite a bit longer than your normal bulb.  Annoyingly, I managed to trip the fuse, which normally wouldn't be an issue until I located the fuse. I can't say I've ever come across this. I had lucked out that someone nearby had a spare, but oddly enough Toyota dealerships seem to keep this in stock. I ordered some to keep in my stash and as luck would have it, someone else nearby tripped the same fuse so I passed on the favour.  I also did a little service on the 110 ahead of some additional work coming up. It's been annoying that Goleby's stopped carrying this particular HKS filter for the 110, so now I need to keep them on order from Japan. I also took the opportunity to install a bash plate and number plate riser. The plate riser is such a cheap but nice fix to help really tidy up the car. I'm tempted to now also replace my headlights, on this car. Both items were from Project Aero.    I also needed to replace the rear tyres on the 110, and after trying to get it aligned learnt that I need to replace some bushes in the front end, so that's next.  Closing out this update with a nicer picture as always! 
    • Yeah mate, never miss it.
    • Any going to watch World Time Attack at SMSP this year?
    • Appreciate the correction on the "ground", that will make a huge difference to looking at this. That makes complete sense about AF70/AF71 which is what I had come down to being the issue, one of these. I'll have another look in the ignition wiring when I get a chance next week. I'll also make up a jumper wire for running that AF73 test.  ECU is fine, relay itself is fine, pump harness is fine and the pump itself is fine. I am going to upgrade the Walbro 255 anyway with a DW300 I have since I need to replace the fuel sender and I'm going to upgrade the FPR with my chasebays kit ready for new plenum/injectors/dbw, but I'll get this working first. That's why this is so frustrating. 
×
×
  • Create New...