Jump to content
SAU Community

Popularity Of Kerala’S Ayurvedic Centres

austin12

By austin12,
in Health & Wellbeing

 Share

Recommended Posts

austin12 Newbie

austin12

Posted
Posted

Kerala has become famous for its Ayurvedic centres, these centers have rendered an innovative and new concept to Ayurveda. These ayurvedic centers in kerala have attracted tourists from far and wide to indulge in treatments. There many different kinds of massages with herbal extracts, ministrations with medicated oils and therapies conducted to heal the patients. These ayurvedic treatments are effective against various illnesses and patients from various countries have healed in these processes. Ayurveda has secured a niche of its own in the contemporary era. It has blended well with the modern life and tackles the various ill effects of the hectic routines. Many young persons visit Ayurvedic centres for detoxification. These ayurvedic centres in Kerala increases the energy level and revitalises the body. Many of the tourists are patrons of this treatment. Elders also vouch by the norms of Ayurveda and lead their lives by it, they prefer Ayurveda to other alternatives. The secrets of longevity are bonded with Ayurveda, the elder generations are aware of these facts. They resolve to abide by the various norms of Ayurveda in their life span. Ayurvedic centres have become famous with better awareness about various health factors. Renowned Ayurvedic doctors consult the patients and provide the adequate treatments. Ayurveda has become competent and it has secured a niche in the modern lives. Many tourists have included it as a part of their health routine. There are several patrons for Ayurveda and Ayurvedic centres from far and wide.

GTR-N1 Grand Master

GTR-N1

Posted
Posted

Some Ayervedic meds are stand-outs.

Others I regard as useless.

The single one I use is so spectacular, SBS decided to film a special on it.

NEEM

* kills off Candida Albicans

* nullifies Herpes Simplex and to a certain extent Herpes Zoster

* prevents low blood sugar and diabetes 2 by helping insulin resistance - especially in conjunction with the herb, Gymnema Sylvestre

* can kill forms of Staphyllcoccus Aureus but I'm not sure if it's able to knock off MR Golden Staph or VR Golden Staph (regarded as superbugs)

Neem Indica - It's worth noting for yourself or a family member

Trozzle Grand Master

Trozzle

Posted
Posted

Tis my way of proving to myself that I don't quite have dementia yet ;)

But hey, can any good come out of my POS post? Only a reader can tell!

Plenty of good can and likely does come out of them mate :)

Mitcho_7 Mentor

Mitcho_7

Posted
Posted

NEEM

* kills off Candida Albicans

* nullifies Herpes Simplex and to a certain extent Herpes Zoster

* can kill forms of Staphyllcoccus Aureus but I'm not sure if it's able to knock off MR Golden Staph or VR Golden Staph (regarded as superbugs)

Neem Indica - It's worth noting for yourself or a family member

Is that in vivo?

Mangune Mentor

Mangune

Posted
Posted

Some Ayervedic meds are stand-outs.

Others I regard as useless.

The single one I use is so spectacular, SBS decided to film a special on it.

NEEM

* kills off Candida Albicans

* nullifies Herpes Simplex and to a certain extent Herpes Zoster

* prevents low blood sugar and diabetes 2 by helping insulin resistance - especially in conjunction with the herb, Gymnema Sylvestre

* can kill forms of Staphyllcoccus Aureus but I'm not sure if it's able to knock off MR Golden Staph or VR Golden Staph (regarded as superbugs)

Neem Indica - It's worth noting for yourself or a family member

Will take note as the missus had Candida.

GTR-N1 Grand Master

GTR-N1

Posted
Posted

Yeah, men get it as crotch itch but they (unless gay or Drs) won't talk about it to other men > suffer in denial hehe

Other symptoms are a type of tinea, foggy thinking, bad breath, blocked sinuses, post-nasal drip, bruise easily with slight bumps, rashes in sweaty areas, wind/flatulence, loose motions...

Arises when antibiotics kill off the friendly gut flora > Candida comes up from the colon to reside > can cross the gut wall > systemically lodges into moist areas of the body

Yeast, sugar, sweets, beer, wine, bread keeps the Candida flourishing > slows down metabolism too > weight gain.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Duncan
      From Japan and back to Europe, my sh*tbox R34 GTT

      By Duncan · Posted

      Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Duncan
      New

      By Duncan · Posted

      Welcome to SAU, what are you looking at buying?
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
    • hoodedreeper
      Chris' Toyota Mark ii JZX110

      By hoodedreeper · Posted

      I wanted to try and preserve the front bumper as long as possible, they're not cheap and are made to order in Japan. Taking inspiration from my previous K11 Micra build where I made an undertray for the Impul bumper, I did the same for this BN Sports bumper but a little slimmed down.  This time round I only made a 'skid plate' (if that's the correct wording/term) for just the bumper surface area, the Micra version covered the gap like an undertray. Starting off with a sheet of mild steel approx. 0.9mm thick 4ft x 2ft in size. I traced around the bumper, cut it out and cleaned the edges. Luckily I was able to get two halves from one piece of metal In the video I installed it as is, but I've since then I've removed it to spray and add a rubber edging trim. The rubber trim is suitable for 1-2mm and it's a really nice tight fit. The bolts had to be loosened due to the plates being too tight against the bumper, the trim wouldn't push on I used some stainless M6 flat headed bolts for a flusher finish (rather than hex heads poking down), I believe this style fastener is used for furniture too incase you struggle to source some. The corner's are a little wider, but this may be an advantage incase I get close to bumping it  The front grill got some attention, finally getting round to repairing it. Upon removal one fixing pulled itself out of the plastic frame, one side is M8 that fixes inside of the frame, where as the other side is M5. Not knowing I could get replacements, I cut down an M8 bolt, threaded it inside the frame along with a decent amount of JB Weld.  The mesh was replaced to match the bumper. One hole on the bonnet/hood had to be drilled out to 8mm to accommodate the new stud, once the glue had set it could be refitted. I think the reason the grill was double meshed was to hide the horn/bonnet latch (which makes sense) but I much prefer it matching the bumper Bumper refitted and it's looking much better IMO The Youtube video can be seen here: https://www.youtube.com/watch?v=bVZP35io9MA
    • hoodedreeper
      Chris' Toyota Mark ii JZX110

      By hoodedreeper · Posted

      The video for the servicing and fuel filter change can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44 One of the main jobs I wanted to do before the car officially went on the road, was to remove the awful looking blue silicone hoses. There's nothing wrong with having coloured silicone hoses, but I realise as I'm getting older I prefer monotone engine bays with a splash of colour on the engine cover(s). I cover this in a lot more detail in the Youtube video, so unfortunately there's limited photos of the process. The intercooler, upper radiator, boost vacuum and upper breather hoses were all changed to black silicone with mikalor clamps. The only blue left is a blanking cap at the back of the inlet manifold and the GReddy pulleys (which will be replaced for stock when the cambelt gets replaced) While the intercooler pipes were off I gave them a quick clean/polish too A before photo I do have a replacement air filter on its way. Fuse box covers were painted blue, they're now satin black Another job on the list while the bumper was off, is to add some mesh https://live.staticflickr.com/65535/54737966256_99b28bfa30_c.jpg[/img] I was hoping to use some thin wire to secure it, but it seems I've misplaced it and the wire I had was too thick to twist easily. I ended up using cable ties for the time being https://live.staticflickr.com/65535/54737131882_c2b7989dcc_c.jpg[/img] Was pleasant to see this https://live.staticflickr.com/65535/54737131627_8b2aab13b3_c.jpg[/img] The last thing to do was to fix the front grill and re-mesh that to match but I ran out of time The Youtube video can be seen here: https://www.youtube.com/watch?v=R4FsF6tgizE&t=23s
×
×
  • Create New...