Jump to content
SAU Community

Recommended Posts

Ok i was driving it was fine then massive loss of power on accleration so i start heading home and the car stalls and goes up in whiy smoke out the exhaust and engine, i try restart it and it strts and the engines clunking an trying tonstall and theres white smoke everywhere

Link to comment
https://www.sau.com.au/forums/topic/422589-is-my-car-dead/
Share on other sites

blown head gasket perhaps or what i done to my old motor same story was driving then all of a sudden sounded like a massivley cammed V8 and white smoke everywhere and overheating after that

i had to look at the way the engine was treated serviced every 5,000K's and looked after untill i had the shits one night and done skidz on the limmiter for a night explains why it let go a couple of days later

when i pulled the engine apart i found 2 shattered pistons and a blown headgasket due to oil passing through the rings and too much compression in the cyl

DO A COMPRESSION TEST!!

Link to comment
https://www.sau.com.au/forums/topic/422589-is-my-car-dead/#findComment-6800235
Share on other sites

lol, throws a rod out the block... which can be checked via quick check under the bonnet.

but posts thread on SAu first asking for advice

Or maybe asked for advice then decided to bring to a workshop who tested it, that could perhaps be it and it snapped from a possible boost spike

Link to comment
https://www.sau.com.au/forums/topic/422589-is-my-car-dead/#findComment-6807133
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...