Jump to content
SAU Community

Recommended Posts

i had a gtx3076 in 0.82 external gate form and it was a little dissapointing how late the rush came on 98 fuel, even with E85 it was a doughy unless the revs were at 4000rpm onwards where it would react with massive wheelspin ( setup dependent).

I dont know if an OP6 housing would flow as much as a garrett so it might have better response but then choke up top,

you'd be better off with a GT3076 with a Garrett 0.63 or 0.82

Edited by AngryRBGTX
Link to comment
https://www.sau.com.au/forums/topic/423351-gtx3076/#findComment-6812792
Share on other sites

I think its going to cook the OP6 rear housing tho. that comp wheel is good to run on external gate with a .82 turbine housing. If you have to use that OP6 rear housing with a GTX core then chose the gtx3071

Link to comment
https://www.sau.com.au/forums/topic/423351-gtx3076/#findComment-6812874
Share on other sites

GTX3071 for the win! Better response and better comp to turbine ratio.

Yep, steer clear of the GTX3076 for low boost/power combos as from what i can see its better suited to someone looking for a GT3582 type result :)

Mick_o set the bar for the GTX3071 and it seems to be a hell of a street combo!

Link to comment
https://www.sau.com.au/forums/topic/423351-gtx3076/#findComment-6813273
Share on other sites

Apologies that I don't follow these threads too closely - what is the general consensus on the OP6 housing allowing in terms of flow? I would be surprised if it would even allow a GTX3071R to be utilised properly. Is this case one where a GTX3067R might be worth considering?

Link to comment
https://www.sau.com.au/forums/topic/423351-gtx3076/#findComment-6813283
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • There's not a great deal to report here .... except ...... FOR .... LSD!!!  I bought a Quaife LSD from the UK and shipped it here .... Wish I'd just bought locally cause the shipping and duty was $700! But there were so many diffs used in the E90s I just wanted to be absolutely certain I was getting the right one so I spoke with a supplier in the UK who builds race cars and they have heaps of experience with the E90s.  I pulled the diff out which was seriously awesome - I've never done anything like that before, I must have watched 1000 videos on YT about it as well as consulting the Bentley manual. It was super easy in the end. The diff was delivered to the awesome folks at Hornsby Diffs and will be back in a few weeks. I also replaced the diff bushings with some Nolathane ones.  Really looking forward to getting it back and getting back to the track or even the skidpan.
    • yeah... the 13kg/mm springs weren't always in there, I had 10kg/mm but doing a few SMSP commanded heavier front springs. It's so good now going into T1 and T2, just need more seat time and real tyres.
    • Yes, well. Mine are less than half that. ARBs are not set to "dumb" either.
    • I would hope. But, we all know even the best companies have an issue sporadically.
    • LOL well, lucky mine doesn't have some R shit on it. Around town, it handles so much better than the R33, R33 in the wet is pretty dangerous to the untrained hoon, especially with 13kg/mm front springs.
×
×
  • Create New...