Jump to content
SAU Community

Fuel Consumption

Spinning
 Share

Recommended Posts

Spinning Contributor

Spinning

Posted
Posted

Hey every one, Ive got a R32 Rb20det Gtst thats only getting around 250kms per tank with BP98 driving sensibly. It has a 3" straight through exhaust, a big front mount and a RB25 turbo.

I cant find a reason why im getting such low K's!

Could it be it just needs a tune with those mods?

Could any one suggest any thing to check please.

Link to comment
https://www.sau.com.au/forums/topic/424762-fuel-consumption/
Share on other sites
mad082 Grand Master

mad082

Posted
Posted

how many litres are you calling a "full tank"? the tank is 65L. are you running it until the car simply runs out of fuel? are you running it until the fuel light comes on, cause there is roughly a 10L difference in amount of fuel used there. and if the light isn't coming on before you get fuel then there could be anywhere up to about 20L of difference in fuel used.

so how about you start calculating your actual fuel economy in litres per 100kms driven, and then we can give you an indication of whether you are just getting the typically poor fuel economy that turbo skylines get, or whether you have something actually wrong.

mad082 Grand Master

mad082

Posted
Posted

Ok so that's roughly 16l/100kms. Depending on how you drive then that's only slightly poor economy. If you like to give it a squirt and do a fair bit of driving in stop/start traffic then it isn't too bad. If you do plenty of highway driving then it is a bit crappy

Kinks Grand Master

Kinks

Posted
Posted

As above the fuel light is ridiculously conservative. Your R32 may be different but on my R33 I have seen the fuel light come on at 1/4 tank before!! I wait until my needle first drops BELOW the empty mark and then I know I have about 10 litres left in the tank and a range of around 50km before I really should fill up. I can consistently put in between 55L and 58L so you are filling up way too soon.

km per tank is meaningless, unless you are really pushing it close to empty it's not "a tank" anyway. The ONLY way to tell people your consumption is in litres per 100km.

My r33 gets around 12.5L/100km in typical, gentle driving to and from work. Bear in mind I have minimal start-stop traffic it's usually cruising at a steady 60-80km/h depending on the speed zone. If you are in start stop traffic your consumption goes to poo. If you put the boot into it your consumption goes to poo. If your O2 sensor is stuffed or you got a cheap tune your consumption goes to poo. I did a tank recently after flogging my car more than usual and it was above 14L/100km, it surprised me. But that's a car that I know is in perfect nick because I always get great economy on it. A dud O2 sensor will easily cost you more in fuel.

mad082 Grand Master

mad082

Posted
Posted

As above, there are so many variables in fuel economy. If you let the car suit and idle for a while before driving then you will get worse economy (and it's not needed). While low revs help economy, low amounts of throttle help more. If you floor it but only rev to 3500rpm you will use more fuel than someone who revs to 4500rpm but uses light throttle. Also driving short trips will result in poor economy.

There are mechanical issues that can cause poor fuel economy though. O2 sensor as already mention, dodgy thermostat (if the car doesn't come up to temp within about 5 mins if driving then get a new thermostat), dirty air flow meter, sticky brakes.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Kapr
      ECU sees many times the speed than speedo does (R34 swap)

      By Kapr · Posted

      The car/ECU will have all the sensor that it needs and expect to have. I think i do not have to explain to you how the Link is way better specialy if you have swapped engine   I just do not want to deal with any "problems" cuz i have only Nistune which i learned is not that great and in my case cant even deal with that speed problem (Link can) And of course it will be way more easier to tune and diagnose and safe. And for the ECU/speed problem...i dont know.
    • wizlb
      Who has a Infiniti Q60, Q50 (V37)?

      By wizlb · Posted

      Per Mark Roberts of Sonictune: Mark Robert Author At this time, no. No ETA either 2016-17 models. You will be able to purchase and install a 2018.5+ TCU though   TCU purchasing and pricing info! As we near the release of TCU tuning, I am going to answer some questions I get asked often.   What do I need for TCU tuning? At this time, you will need a 2018.5+ TCU to be able to tune. If you have a 2016-to early 2018, you will need to replace your TCU with the newer version. One good way to know if your TCU is good is if you have auto upshift in manual mode in 1st gear around 6500 rpms. If your manual 1st gear goes to 7k rpm and will hit the rev limiter unless you shift, you have the older TCU.   Why do I need to buy another ecu license/phone flash if I already have it on my ECU tune? The TCU is its own computer module. It is completely separate from the ECU. Because of this, you will be required to purchase a TCU license and, if your tuner has it, the phone flash license required to tune it via phone/bluetooth.   Do I need TCU tuning? TCU tuning is NOT required. However, the faster your setup, the more it will assist in track and dragy time consistency.   If I’m ECU tuned by (tuner A) can I get my TCU tuned by (Tuner ? Yes, since it’s a different module and a completely separate flash, you can have two different tuners. However, it is highly recommend that you have both tuned by the same tuner. For me, my TCU tuning will directly complement my ECU tuning style and features and running my ECU and another TCU or vice versa MIGHT cause some issues. At this time and for the foreseeable future, I will only be tuning my current ECU tuned customers TCUs.     I have a SYVECS AWD controller. Do I still need it? Yes! The AWD controllers main job is to control your AWD system. However, with TCU tuning, you will no longer need the auto-shift function as that will be done through the TCU. The AWD controller will still be very beneficial for racers looking to maximize traction on the launch.     Shift schedule changes: holding gears longer at lower pedal input as well as max shift rpm changes. Please note, the new ECU race rom coming out will address 90% of the shitty drivability issues these cars have through custom maps from myself and Racebox—as well as others I am sure.   Increase shift speeds: as seen in the videos I’ve been posting, the TCU shifts much faster once tuned.   Increased shift pressures: as also seen in the videos, much firmer full throttle shifts.      
    • wizlb
      Who has a Infiniti Q60, Q50 (V37)?

      By wizlb · Posted

      Per Mark Roberts of Sonictune:     Mark Robert Author At this time, no. No ETA either 2016-17 models. You will be able to purchase and install a 2018.5+ TCU though   TCU purchasing and pricing info! As we near the release of TCU tuning, I am going to answer some questions I get asked often.   What do I need for TCU tuning? At this time, you will need a 2018.5+ TCU to be able to tune. If you have a 2016-to early 2018, you will need to replace your TCU with the newer version. One good way to know if your TCU is good is if you have auto upshift in manual mode in 1st gear around 6500 rpms. If your manual 1st gear goes to 7k rpm and will hit the rev limiter unless you shift, you have the older TCU.   Why do I need to buy another ecu license/phone flash if I already have it on my ECU tune? The TCU is its own computer module. It is completely separate from the ECU. Because of this, you will be required to purchase a TCU license and, if your tuner has it, the phone flash license required to tune it via phone/bluetooth.   Do I need TCU tuning? TCU tuning is NOT required. However, the faster your setup, the more it will assist in track and dragy time consistency.   If I’m ECU tuned by (tuner A) can I get my TCU tuned by (Tuner ? Yes, since it’s a different module and a completely separate flash, you can have two different tuners. However, it is highly recommend that you have both tuned by the same tuner. For me, my TCU tuning will directly complement my ECU tuning style and features and running my ECU and another TCU or vice versa MIGHT cause some issues. At this time and for the foreseeable future, I will only be tuning my current ECU tuned customers TCUs.     I have a SYVECS AWD controller. Do I still need it? Yes! The AWD controllers main job is to control your AWD system. However, with TCU tuning, you will no longer need the auto-shift function as that will be done through the TCU. The AWD controller will still be very beneficial for racers looking to maximize traction on the launch.     Shift schedule changes: holding gears longer at lower pedal input as well as max shift rpm changes. Please note, the new ECU race rom coming out will address 90% of the shitty drivability issues these cars have through custom maps from myself and Racebox—as well as others I am sure.   Increase shift speeds: as seen in the videos I’ve been posting, the TCU shifts much faster once tuned.   Increased shift pressures: as also seen in the videos, much firmer full throttle shifts.      
    • The Bogan
      NC MX5

      By The Bogan · Posted

      The fancy pants red shock tower brace is finally incoming from MX5 Mania, getting it shipped from 'Merica has been a long and problematic process, and GWR, the 'Merican supplier will not ship directly to consumers outside of the US, Mania basically had to order a heap of them, the colour choice was silver, or red, and we all know anything red adds 5 killerwasps of dynotorques..... Whilst it does fit over a 2.5, and I've seen a few photos and videos of it being installed and fitting, google also says it might get real close to the FAB9 intake front runner, people in the US says it does fit with the FAB9 intake, except for one person who said it slightly touched.......so there is that.....LOL..... As it seems that I am the first in AU to have this combination of parts there's no local knowledge about fitment, so I'm just a willing guinea pig in this endeavour, I'll cross my fingers and toes and hope for the best In other news, I ordered stuff from China  on the same day I ordered the 23° silicone bend from Victoria, the stuff from China arrived a day ago, the 23° silicone bend is still travelling around Australia thanks to Australia Post, and "may" be here next week
    • Duncan
      Who has a Infiniti Q60, Q50 (V37)?

      By Duncan · Posted

      Very good news...I contacted Racebox about it last night. My car is a 2016 so remains to be seen if it is compatible, requires a TCU swap, or is impossible.
×
×
  • Create New...