Jump to content
SAU Community

Advice On Wheels On A Rs260

e-clip
 Share

Recommended Posts

gts_koop Enthusiast

gts_koop

Posted
Posted

I think it could be done 'fairly' easily. You'd need to run spacers to shift the inner part of the rim away from the rear shock and front camber arm. I'd guess at least 10-15mm. Then you'd definitely need to roll your guards quite aggressively...or purchase over fenders.

Will look pretty tough if you don't mind a bit of mucking around to get it together.

For your reference, from what I've heard the best rim combo to slip straight on with no mods is 9-9.5" width with around a +12 or thereabouts offset

numleg Community Regular

numleg

Posted
Posted

I have run 19x9.5 + 12 with 25mm spacers on the rear, was running 245/35 rubber and could have gone up to 255's.

I'm now running R34 GTR rims and 265/35/18 and rubber and 25mm spacers, car drives about 10099993785492569% better. Bloody close to rubbing springs on the inside though.

It would be a VERY tight fit/may not fit, you will need spacers, camber, stretched rubber and rolled or probably flared guards to run the 10.5.

It will look fat as all f**k though.

  • 2 months later...
oscillo hero Contributor

oscillo hero

Posted
Posted

i have a set of these on my black 260. http://www.koya.com.au/?cars=endless-black-s2c-19 mine are 245 wide and not sure of offsets. we made front and back the same offset between the two offsets on the front and back of the standard mags. they clear the brembo's fine and can be customised to the desired offset at the factory. the biggest issue i found with mags was caliper clearance and in qld spacers are illegal and will get you defected

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      What brakes on R34 GTT(Europe)

      By Dose Pipe Sutututu · Posted

      Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • soviet_merlin
      WGNC34 - floor mats

      By soviet_merlin · Posted

      Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • joshuaho96
      Tomei gasket

      By joshuaho96 · Posted

      I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • GTSBoy
      What brakes on R34 GTT(Europe)

      By GTSBoy · Posted

      The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Kapr
      What brakes on R34 GTT(Europe)

      By Kapr · Posted

      Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...