Jump to content
SAU Community

Recommended Posts

Hi all,

Just bought my brothers r33 gtst which is hunting whilst driving or idle..

It was blowing some black smoke which has stopped since replacing the fuel filter, spark plugs and oil filter/oil.

At the same time the hunting stopped so i thought i had fixed it however today it started again....

I am sus to it being the coil packs ?? (does this sound like a possibility?)

didnt want to pointlessly buy some so was wondering if anyone in Penrith/western sydney has any i could try and see if they fixed the problem?

Link to comment
https://www.sau.com.au/forums/topic/430698-r33-gtst-hunting/
Share on other sites

Hunting during idle is typically due to additional air getting into the system which the air flow meter isn't registering. This is due to a leak somewhere.

The most likely culprit is the black charcoal box that they have to install when importing for emissions reasons. One of the hoses that comes out of this feeds back into your plenum. If you plug the hose with a ball bearing and the hunting stops you've found your culprit. Other points to check are the multitude of vacuum hoses that run around the engine but you don't often see these leaking.

  • 2 months later...

OK guys, reviving a bit of an old post, still having issues...

symptoms:

Car is hunting (not always) on idle...

when driving there is a miss (sometimes not consistent)...

when driving revs cut out completely but the boost gauge on the dash says its still on boost (do not need to be driving hard - intermittent)...

Fix Attempts:

Cleaned the AFM

Cleaned the AAC Valve

Changed Spark Plugs

Changed Fuel Filter

Changed Oil Filter

Changed cracked vacuum hose coming off of the plenum (just above the aac - went back to a black box)

Plugged above hose after changing it didnt help

New genuine o2 sensor

I'm out of ideas, the only thing i have yet to try would be coil packs but dont want to spend all that money and it not be the problem. any other suggestions?

OK guys, reviving a bit of an old post, still having issues...

symptoms:

Car is hunting (not always) on idle...

when driving there is a miss (sometimes not consistent)...

when driving revs cut out completely but the boost gauge on the dash says its still on boost (do not need to be driving hard - intermittent)...

Fix Attempts:

Cleaned the AFM

Cleaned the AAC Valve

Changed Spark Plugs

Changed Fuel Filter

Changed Oil Filter

Changed cracked vacuum hose coming off of the plenum (just above the aac - went back to a black box)

Plugged above hose after changing it didnt help

New genuine o2 sensor

I'm out of ideas, the only thing i have yet to try would be coil packs but dont want to spend all that money and it not be the problem. any other suggestions?

The miss could be caused by the coils, but I am not sure if it is causing the hunting. If the car has done well over 100k kms, the coils should be changed anyway. A set of splitfires set me back $400 and were easy to install, and should last you another 100k kms and will last with any mods you plan on doing.

Like Plattsy said, try a ecu reset. Although I didn't think it needed to be off for 24 hours, I would have thought 20 mins would be enough.

The miss could be caused by the coils, but I am not sure if it is causing the hunting. If the car has done well over 100k kms, the coils should be changed anyway. A set of splitfires set me back $400 and were easy to install, and should last you another 100k kms and will last with any mods you plan on doing.

Like Plattsy said, try a ecu reset. Although I didn't think it needed to be off for 24 hours, I would have thought 20 mins would be enough.

you can do it in twenty if you pump the brakes or some shit. but i always left it for a day to be sure.

Tried the ECU now, no good still the same. the annoying this is its not consistent, at first it ran well but shortly after started having the same issues. Any other ideas? I was thinking due to it being intermittent it might be some sensor or electrical fault?

OK, car ran good for about a week, played up again, ran good another 2 days, played up and now seems to have a constant issue of the car starting to drop revs when i go above 2500 RPMs in any gear. If i stay below the 2500 the car is running fine.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
    • Lock me in mate, although I'm not sure if I'll be heading up from Goulburn or down from Sydney, either way, return will be back to Goulburn 
    • Sounds good, we will aim to be there! @The Bogan I'll give you a shout if you are heading up to campbelltown for the meet too.
    • Before I get to the test day, just to finish off the android head unit. This is a demo from car start up....the standard/host system takes a few seconds to boot (same as all v37) but Android comes up quickly. In this vid I'm using the delivered launcher but have set the default to Agami since which is easier to navigate when if use primarily 5 apps. You can see the host system still takes over when required eg putting it in reverse, and you can switch between Android and not by holding the back button 3 sec. It is pretty responsive (fast) but you can see I had to press harder than expected a couple of times.  I still have the phone connected to the stock system, and that also seamlessly takes over Android music playing. v37-android-demo.mp4 The bigger reason that I put this in though is so that I can use Ecutek directly on the head unit. That gives me a dash with logging (up to 20MB only), high and low value warnings on any parameter etc etc. I've run a USB cable from the Ecutek OBD dongle to a USB input on the unit, easy. v37-ecutek-demo.mp4   The unit did freeze on the launcher the other day, I think Agami was trying to verify the license when it didn't have a data connection...will monitor and report back if there are any other problems but so far I'm very happy with the upgrade.
    • Nah that is just crappy GPS mapping, I did have a small excursion (cold tyres, damp track, surprise!), will post up that when I get a chance.
×
×
  • Create New...