Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Morning mate

Sounds like a good plan

Igniter is in the coils, does not look like loom or coils TBH they operate under load and at speed, not plugs either.

Background on the car:

400rwhp r34 gtt

never had an issue with missfire ever

109000K's

only missing at revs while free revving

no issues under load or at max boost (23psi)

Igniter should be a separate unit consisting of transistors/diodes. they are on the back of the rocker cover on rb26s - not sure where located on r34gtt. They are also referred to as a Power Transistor Unit

I believe that in s2 Rb25's and neos, the ignitor is inside the coilpack. Unlike the s1 Rb25. I'm not familiar with 26 setups though

RB26's have their igniter module at the back on top of the plug covers.

rb25s - Answered

MagicMikeZ32 would know all about them failing lol

Mine were 20+ years old, no issues. Don't even need engine out to change them.

Having said that, I am using yellow jackets at the mo, for no aparant reason other than 'modify'

Mine were 20+ years old, no issues. Don't even need engine out to change them.

Having said that, I am using yellow jackets at the mo, for no aparant reason other than 'modify'

Not the coils the PTU in Z32s. I had to replace mine. http://forums.nicoclub.com/tip-for-ptu-problems-t276337.html

http://tech.aus300zx.com/ignition/ignition.htm

I believe that in s2 Rb25's and neos, the ignitor is inside the coilpack. Unlike the s1 Rb25. I'm not familiar with 26 setups though

So thats the difference between S1 and S2 packs.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • I think he was only proposing to use the wire, not the sender. Simply because it runs from the right place to the right place. Personally, I wouldn't hack up the factory wiring like that. I'd just lay in the Defi loom.
    • From memory it wasn't too hard to simply see which wire ran where when you plug that in. Unfortunately also from memory the OEM sender does not use the same configuration 99.9% of gauges run. So in other words if you connect the signal wire that was running to the OEM gauge to your DEFI gauge you might find your oil reads at 200C or some other incorrect value. I remember having the same line of thought and then running new wires/senders to match the gauges I have. The pinout is available in the R34 workshop manual.
    • Does anyone on here know which wire on the GTT triple gauge pod harness is for the oil temp gauge? my sensor works fine but I upgraded the gauges to DEFI advance. And if I can simply piggyback off the oem oil temp wire to the Defi oil temp sensor wire that would make life so much easier. 
    • Even face her a wash now that’s it worth more than my house
    • This was what I was invisioning, or Pete cutting a beer can up and hose clamping it around the catch can! Ha ha ha
×
×
  • Create New...