Jump to content
SAU Community

Mugabetown - Whoretownin' At It's Worst.


Recommended Posts

Sup Y'all?

I've been hiding... Busy working too much, getting a house built, planning weddings... The usual time consuming stuff...

Damn work made me miss pork knuckle :( It's been a whole 4 days since my last pork knuckle :( But that one was at Barvarian Bier Cafe not Z german club...

No more like.... *Marp marp marp marp marp crush grind ping knock knock knock knock*

This was more along the lines of it.. it was telling a lot of poor knock knock jokes till it was no more. Driving it home in 5 cylinders didn't help either

u need to get it checked out man. I think it's internal sadly :(

sigh... ill keep looking for something. might try and do a comp test and check for leaks this weekend.

would a small leak cause it to hunt like that? or a possible dead coil pack?

i unplugged the AFM and still ran shit dont think its a air leak...

sigh... ill keep looking for something. might try and do a comp test and check for leaks this weekend.

would a small leak cause it to hunt like that? or a possible dead coil pack?

i unplugged the AFM and still ran shit dont think its a air leak...

facts are as follows Ed:

1. Something went bang whilst driving / been driven

2. Big puffs of smoke coming out the exhaust (what color is it BTW?)

3. Engine runs like a donkey ever since noise occurred

4. New set of plugs did not fix the problem

5. Take the guidance of Ants and see a Mech for diagnosis of engine

Yes, leak test and comp test are on the cards Ed.

Im guna say it.

I call bs it went bang at idle. You were boosting and split a hose. Do a boost leak test, check all hose clamps, ic piping etc.

seriously it was sitting at lights when it happen didn't even boost it cause car was still cold.... so from that video you would look for a split ic piping ect?

seriously it was sitting at lights when it happen didn't even boost it cause car was still cold.... so from that video you would look for a split ic piping ect?

just watched the vid. Sounds terrible but could be the location. Let idle and pull coil pack connectors 1 at a time and see if rpms change. If the rpms drop on a particular cyl report back. Edited by MagicMikeZ32

just watched the vid. Sounds terrible but could be the location. Let idle and pull coil pack connectors 1 at a time and see if rpms change. If the rpms drop on a particular cyl report back.

ok will try this in the morning pending time.

G nite all

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
×
×
  • Create New...