Will A Single 450L/ph Walbro Support 400Kwatws?

[SiR_RB]

Plenty of people using them for a while now

[KiwiRS4T]

At 13.5v and 40 psi rail pressure it advertises 430l/ph and on 12v at 40 psi it flows 375l/ph.I plan on running a direct feed to get near 13.5 volts.So at 40psi pressure should outflow 2x 044s.I was toying with the idea of the bosch id2200cc injs.Thanks guys

My 550 Deatschwerks are handling 314AWKW at 90% max duty so I figure that even on E85 ID1000s should give you plenty of margin with some room for increased power but if you have the money and the desire to go bigger then why not. The Walbro might outflow the 044s at 40 psi but what boost are you running? What are the flow comparisons at 65psi? ...Hmm did a little Googling and it would seem the answer is about 330 lph and some suggest it is good for about 550hp so should do you ok for now.

[scotty nm35]

One of my R33gtst customers maxed a 460L at 430kw on e85 recently. I suggested he run twin 460's.

[SiR_RB]

What psi boost?

[SiR_RB]

Just spoke to Jez, he made 437rwkw with a standard walbro 400lph on 23psi boost standard fuel reg

[Ben C34]

Just spoke to Jez, he made 437rwkw with a standard walbro 400lph on 23psi boost standard fuel reg

I assume that's 98?

[SiR_RB]

Caltex eflex

[Deano 1]

It had a bit of wheel spin when he was running it up. Plus the radiator was blowing off cause the head gasket was letting go as it was factory. So it would have made even more than 437 if the conditions were right.

Considering it was 1am in the morning the night before his wedding I think it was a good effort lol

[n_D]

My car will be running on a 25neo, single 460lph walbro e85 pump with a tomei reg and 1200cc bosch injectors. Precision 6266 0.84a/r.

Ive seen plenty of people making big power off the single pumps, so atm til it actually runs and a problem comes up the single pump should work fine.