Jump to content
SAU Community

Recommended Posts

After over a million votes were cast, Ferrari have revealed their 2014 car will be called the F14 T.

http://www.planetf1.com/driver/18227/9131012/New-Ferrari-called-the-F14-T

And the lotus' proboscis are not equal length either!, with the left one about 5cm longer.

1390581202.jpg

The rules mandating a single nose tip, to be mounted far lower than previously and with a minimum cross section, were introduced for safety reasons.

The other cars that have so far been revealed have featured the 'anteater' nose, which forms the nose tip with a finger-like extension.

Lotus's twin tusk arrangement eschews this philosophy and stretches the wording of the rules to the limit.

In order to meet the single lower nose tip regulation, the two tusks are of unequal length, so the longer one forms the mandatory nose tip, while the other is short enough to avoid being considered part of the nose tip by the regulations.

This leaves each tusk to act as a crash structure, the front wing mounting pylon and then, as they slim narrow the rear of the car, also become turning vanes.

This means the unavoidable obstruction of the mandatory nose tip is made into a multi-purpose device.

The design may present slightly more total cross sectional area to the airflow, but places the obstruction in the most beneficial location.

http://www.autosport.com/news/report.php/id/112265

............... :ermm:

you guys should be happy, Lotus didn't make the penis nose you were so woried about!

McLaren are so broke without a naming sponsor they got Mercedes to throw in a few cans of paint with their engine deal. Car looks pretty good I think.

67839_570117296398695_176835976_n.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
×
×
  • Create New...