Jump to content
SAU Community

Recommended Posts

How to Install Do-Luck Ignition Harness for R33 GTR.

 

post-120471-0-91263100-1394361561_thumb.jpg

post-120471-0-42968800-1394361589_thumb.jpg

post-120471-0-89095800-1394361604_thumb.jpg

post-120471-0-55543000-1394361676_thumb.jpg

Tools Needed:

  • 4mm Allen Key for Valley Cover
  • Pliers for Blow By Hose's
  • 8mm Socket
  • 10mm Socket
  • 12mm Socket
  • 14mm Socket for Strut Tower Bar
  • Ratchet with short extension

Step 1:

Once Strut Tower bar is removed, Use a 4mm Allen Key to remove the 8 bolts from the Valley Cover. Then use pliers to move the clip down the hose of the blow by hose.

post-120471-0-59885400-1394361750_thumb.jpg

post-120471-0-36478300-1394361859_thumb.jpg

post-120471-0-96439200-1394361933_thumb.jpg

Step 2:

Then use a 8mm socket to remove the transistor earth cable, Once that is Done remove the Connector off the transistor unit.

post-120471-0-81321900-1394362024_thumb.jpg

post-120471-0-48234800-1394362096_thumb.jpg

Step 3:

Remove Valley Cover and Unplug Coil Harness Transistor Connector. Next Remove the 6 Coil Pack Connector.

post-120471-0-43722100-1394362745_thumb.jpg

Step 4:

Use a 10mm socket with short extension to remove the Coil Pack Harness Earth Cable

post-120471-0-70385700-1394362199_thumb.jpg

Step 5:

Remove the Intake Side Blow-By Hose and then Unplug Connector. Now you can remove the whole Coil Pack Harness.

post-120471-0-80099400-1394362344_thumb.jpg

post-120471-0-52050300-1394362405_thumb.jpg

post-120471-0-30724400-1394362281_thumb.jpg

Old OEM Harness Removed

post-120471-0-53834000-1394364045_thumb.jpg

Step 6:

Installing the Do-Luck Harness, There are 3 parts to this: The Harness, Earth Cable and Direct Power Feed with Extension Cable.

First sit the Do-Luck Harness in place and connect the harness earth cable and the Thick Blue Earth Cable to the same coil harness earth point. ( Behind Coil Pack Number 6 ).

post-120471-0-09856100-1394362901_thumb.jpg

 

 

Next there is a Connector on the end of the Do-Luck Harness this connects near the intake side blow-by hose.

post-120471-0-81507400-1394363100_thumb.jpg

post-120471-0-63332700-1394363158_thumb.jpg

post-120471-0-46631800-1394363419_thumb.jpg

Once that is done connect all the coil pack connector’s on.

post-120471-0-05674800-1394363650_thumb.jpg

Step 7:

Connect the Thick Blue Earth Cable anywhere in the engine bay. I connected mine near the ABS system.

post-120471-0-17372200-1394363739_thumb.jpg

Step 8:

Connecting the Direct Power Feed with Extension Cable. First Connect the Extension Cable to the end Coil Pack Harness once that is done connect the other end to the direct power feed unit.

post-120471-0-45426800-1394364274_thumb.jpg

post-120471-0-42968800-1394361589_thumb.jpg

Step 9

Connect the Direct Battery Feed Unit to the relay box as shown in the photo below and then connect the Direct Battery Feed Unit Earth to either one of theses Earth points shown in the photo below.

post-120471-0-50712400-1394363880_thumb.jpg

post-120471-0-16818900-1394363936_thumb.jpg

Now it all Connected Up double check that everything is connected and then reconnect all the transistor plugs and transistor earth point. Then reinstall Valley Cover and Tower Strut Bar.

post-120471-0-17372200-1394363739_thumb.jpg

Step 10:

Everything is DONE!! Start it up and take it for a spin.

Results:

When I started the car up the exhaust tone changed and then I gave it a few revs 3000- 4000 rpm and it wasn’t backfire anymore. Next I took it for a 15min drive up to 7000 rpm and it wasn’t backfiring under boost as it did sometimes.

More testing is required to see if it has removed the under 3000 rpm Miss problem and Backfiring under boost problem.

I will keep everyone posted on further result’s but so far I’m happy with the Result.

  • Like 1
Link to comment
https://www.sau.com.au/forums/topic/440274-do-luck-ignition-harness-install/
Share on other sites

What's the performance difference between Do-luck and OEM ?

I see it says enhanced in the link - what does that mean - how ?

Never mind, Googled

Apparently uses thicker wire for better strength of signal/power (1.6x's thicker)

Coupled with the "direct wire" from battery (extra) improves voltage delivery.

Edited by Sinista32

Took the car out for more testing 70km trip and the backfire problem under boost is gone. The Under 3000rpm miss is still there but not as often.

My Setup:

  • Copper Core Spark Plugs 0.8 gap
  • Splitfire Coil Packs
  • Do-Luck Coil Harness
  • Like 1
  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...