Jump to content
SAU Community

Recommended Posts

Help, my car is dead. Sometime it would start and works for about 15-20 minutes, and then just die. Before the car die., i put the gear in neutral and give throttle, but i just come up to about 5000 rpm and after that it would happen nothing..

Please really need help, no one here in Sweden knows nothing about this car. ( Only 3 nm35 in sweden)

Link to comment
https://www.sau.com.au/forums/topic/444099-my-nm35-is-dead/
Share on other sites

A very similar thing happened to me last year, it was AFM.

Is it drivable for those 20 minutes? If so maybe get it to a Nissan dealership if you can and get them to pull the codes or do as PN-Mad suggested and the gurus here will help you out!

Good luck.

Link to comment
https://www.sau.com.au/forums/topic/444099-my-nm35-is-dead/#findComment-7305853
Share on other sites

anyone know where i can buy a AFM or if anyone know if it is the same for Another car model?

Since you are in Sweden it could take a long while for one of Scotty's AFMs to get to you. I think some of the Subaru ones are compatible (well good enough if you're not too highly tuned), or Nissan X-Trail.

Search Ebay for 22680-AD201 or 22680-4M500, tone of them should get you out of trouble. Then you may want to investigate buying 10+ from Alibaba ($15-$20 each) so you will have a supply for you & the 2 other M35 owners over there. It will be a common thing from now on....

Link to comment
https://www.sau.com.au/forums/topic/444099-my-nm35-is-dead/#findComment-7306158
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...