Jump to content
SAU Community

Recommended Posts

If you are looking for better cooling, check out this Autospeed article first:

http://www.autospeed.com/A_2159/cms/article.html

most bonnent vents will *increase* underbonnet temps.

Also for those raising the back of the bonnet that also does not assist cooling, check out this article:

http://www.autospeed.com/cms/A_1044/article.html

Properly designed kits placed in properly designed positions can improve things, but cutting a couple of holes in your bonnet will not help

  • 2 weeks later...

true carbon fibre shatters on high impacts and is less likely to harm anyone u hit than fibre glass...

personally i think they would look gay... i would just get a glass one and paint it... should only cost about 250 to paint a bonnet not including the inside (no need to).

Heres 2 pics of the dodgy bonnet I did.

- http://www.innaloo.net/~jai/silvia/bonnet.jpg

- http://dgenr8.iinet.net.au/silvia/battle_bonnet.jpg

Basically it was illegal and I did consult the pits in WA about it. I did cut out part of the bonnet support, so the bonnet was a bit floppy. And they said the size of that vent would have been fine IF i ducted the vent soley to the radiator core. The Radiator cap and hoses could not be visible from the top of the vent, so it would have had to be totally sealed. But despite the main support being cut out, if I had strengthened around the vent to give it more rigidity it would have also been ok. The guys at the Pits discussed this with collegues for over an hour!

Also I will note, that from testing using the standard plastic intercooler plumbing on the CA18 Motor, with the vented bonnet the plastic was very cool, if not cold compared to the other intercooler plumbing in the car. With a normal bonnet on it was stinking hot. And yes, you could see a shitload of hot air escaping out of it.

I made the vent with an angle grinder and alot of glass and bog. It was a weekend job. Not sure if my Cefi is going to see the same treatment though :)

JK

  • 4 years later...

AN EXACT REPLICA OF THE R34 GT-R V-Spec II NACA Duct is AVAILABLE FROM

www.kenlowe.com.au in Qld> Raceglass composites > Bodies,Scoops > Scroll down to NACA Ducts 3"

This is an easy company to deal with.

It sits directly over the turbo and no bonnet-reinforcement needs to be cut away.

Mesh made by SAAS can be easily obtained from Autobarn etc.

^^^

I wonder what the Nissan R&D findings are, with regard to the single NACA Duct on the R34 GT-R VS II and the pair on the R35.

By the way, I am in the Cosmetic and Styling Mods section aren't I?

Oh yes.... yes I am!

^^^ hehe... Yep :P

The F/G one costs $45 + GST + Post = $62 to your door.

It can then be fitted from below the bonnet where it'll be moulded and where the hole is cut via a template.

It's OK to PM me with your E-mail for pics of the finished product!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...