Jump to content
SAU Community

Recommended Posts

Dropped off the bottom end today to the machine shop. Getting hot tank acid wash bored honed tunnel squared to deck crank nitrated oil galleries cleaned grub screws fitted to crank. Crank modified for 25 oil pump ballanced and a few other things done.

  • 2 weeks later...

I have been looking at the oil restrictor threads on here and from what I can make out I need to block off the rear feed in the block and put a 1.5mm in the front one. Car is mainly for street use with the odd track day. Or would I be better off with 2x 1mm feeds or 2 x 1.25mm?

Edited by lcxu105

Well your call but 2x 1.0mm gives slightly less flow than 1 x 1.5 but has the security of two feeds instead of one (in the hopefully unlikely event that one gets blocked). On the other hand 2 x 1.25 flow a LOT more than one 1.5 (don't forget you can buy them from me unless you have a better source).

  • 5 weeks later...

Well been a while since I've done anything else. Its going to be a long build. Pick up arp head studs tomorrow. I have a new inlet and exhaust gasket now waiting. Machine shop is making slow process but not worried as I told them I don't want it back until about May June. Have been told that the Nistune won't be able to handle the setup as will have to much air flow for the airflow meter. Will have problems with it stalling. Waiting for Matt from Nistune to get back to me. Worst case I'm up for a new ecu. Any suggestions?

Have been told that the Nistune won't be able to handle the setup as will have to much air flow for the airflow meter. Will have problems with it stalling. Waiting for Matt from Nistune to get back to me. Worst case I'm up for a new ecu. Any suggestions?

Adaptronic.

Whilst Adaptronic or any other aftermarket ECU are perfectly valid suggestions, it is not true that you can't use Nistune because of having too much air flow for the AFM. You can put a Ford Lightning AFM onto it - Nstune can handle it. You can put an R35 GTR AFM's sensor into a 6" pipe and measure 3000HP worth of air if you want to. There's not really any limits from that point of view. The main limit with Nistune is lack of extra functions and sometimes the problems where the stock ECU's self protection behaviours get in the way of tuning more extreme engines. Sometimes there are ways around them, and sometimes there are not. Sometimes the ways around those problems get found before, during or after your build/tune. Sometimes they don't.

I was in the same boat last year. Loved the nistune just the AFM was a little annoying with my intake setup as I am running a 4" pipe. Talk to Matt about a mob over in the U.S that does specialty AFM's. It was what I was going to run as it was perfect for my situation and Matt has already integrated them into nistune.

I have a topic on here about it, search and you shall find.

  • 2 weeks later...
  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...