Jump to content
SAU Community

Recommended Posts

Hey guys I think I have found the cause of my car running rich all the time and eating fuel, can someone please confirm this... (ps I'm running a Power FC)...

So as I take it the actual full tune comes on at 80+ degrees celcius is this correct?

Well my car is barely ever over 80, normally sits around 75, if I give it quite a fanging it gets to 82 then as soon as I drive normally again it goes back down to the 70's range, would this be the cause?

Second question, if this is the cause... would it be because my water temperature sensor is faulty? or is my car just cooling way too much (which I highly doubt) all of the cooling system is still standard, stock radiator, fan, shroud... it's even got a front mount at the front of it which should block some of the cooling so I'm stumped...

Thanks for any help in advance, thanks.

Most likely the thermostat is stuck open.

You can check the ECU's temp sensor. It has a defined resistance at every temperature. Just look up (google) what it's supposed to be at the temperature it will idle at. Then just compare the measured resistance against what the ECU says the temperature is.

Edited by GTSBoy

Well when I go into settings and then water temp correction, 80+ is at 1.00 - 1.00 and the rest eg 50+ are higher so I'm asuming its to put more fuel and and advance timing?, probably does have a nismo thermostat, never really checked since I bought the car, will check it out tomorrow and also write down the actual figures for 50+ etc, thanks.

Most likely a Nismo thermosate, same issue I'm having ATM, the base map on my ECU start coolant multiplier from 75deg escalating as the temp gets colder on the scale, I have to change that as my car sits right on 70deg daily driving and gets upto 76-78 on the track due to the manual clutch fan starting to kick in

you are correct in your analysis that the PFC will assume a base of 1.00 at 80deg water temp +

you can either diag why your water is too cold or simply edit the 50deg+ correction and match it to the 80deg setting.

just be sensible with the car when it gets to around 50deg and ensure its properly warmed up before you flog it

Well I'll try adjust that and just put the 50+ at 1.00 - 1.00 correction and see how that goes coz I feel silly taking a nismo thermostat out and putting in a tridon or something haha lol... if I don't notice much difference then I'll change the thermostat aswell... i did also notice that it always idled a little lower and more power when I do get it to over 80 degrees lol and always wondered why... I will let yous know how I go both with power and fuel consumption.

Throw the Nismo thermo in the shit can where it belongs. Never could understand why anyone would want a colder thermostat. Worst bandaid EVAR!

Probably for track to have more flow? Beats me dude.

Why is this hard to understand ?

Having an engine that runs a little bit cooler is not a bad idea, especially when that coolant is running through the head keeping the combustion chamber temps down a touch

The only problem is fitting them to engines where the ECU can't be adjusted to run properly with them

Engines run better when hotter due to their tune, if your engine has been tuned to run at 85 deg with the engine temp multiplier starting at 80 deg and increasing down the colder scale then you try and run it at 70 deg then no wonder why it runs worse, set it up to run there and tune to run there and it will run there perfectly fine and further away you are from the detenation threshold, obviously you can't run an engine hard at 20deg but 70deg + would make no difference if tuned properly

How about putting a nissan thermostat in?

It may be that you have a normal thermostat and its not functioning properly. Wouldnt hurt to change it out. Only have to drain the coolant, take the 3 bolts for the thermostat housing out and change it

Fresh coolant wont hurt

New thermostat should only be $30 or so. Worth doing if you dont know when it was last done

Yeah I'm going to be doing that... been wanting to change my coolant for a little while now... last time coolant and thermostat were changed was when I had the car imported in 2011 and got the timing belt, water pump and all that done about 30000kms ago... what coolant do you guys recommend? Atm it's got some kind of purple coolant? I think it may be royal purples coolant? From what I've checked out so far I like the look of penrites coolant... although never used it before and unsure, what do you guys use and every how often do yous change it, thanks.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • It was a great, but typical track day, and some VB was ingested at the night time debrief 🤪
    • And so, to round this out, I couldn't be happier to confirm @MBS206 has decided to buy the car. He drove down from sunny QLD with a trailer last week and it is off to its new home today. I'll let Matt confirm on next steps but I understand broadly that the plan is to leave it pretty much as is, and just get some quality wheel time with a nicely balanced car that is pretty much track ready. There are a few a jobs still to be done first but nothing too major and I think its a very smart buy Dinner last night at the Paragon with a round of VBs (mostly) for Neil
    • Well, 50 pages and the end of a chapter for this car. We took it out for a shakedown at Wakie yesterday, and everything went well. There were a couple of niggles: - Oil cooler fitting leak - tightened, cleaned, stopped leaking - Radiator cap overflow fitting was leaking....Mark called it, the overflow fitting was threaded in and not tight....tightened, tested and held pressure - Small oil leak at the rear of the block, probably the turbo oil feed - too hot to get at it comfortably but probably just needs to be nipped up - leak at the driver's side rear brake line where it meets the hardline. Fitting wasn't loose, so Matt backed it off and back on, no further leaks - there's also a leak somewhere on the top of the fuel tank, maybe that cross over fuel line - that was has been left to fix when its on a hoist Otherwise than those niggles the car went great, turned great and stopped great so it was a very successful day out. I'm always really nervous when a car first hits the track after a long break, especially with a brand new engine as well but it was great. VID-20251011-WA0007.mp4  Big thanks to @The Bogan who dropped by and helped out, @MBS206 and my nephew Lachlan the apprentice.  Neil's wife Mel also surprised the hell out of all of us by dropping by; she's up in Tamworth these days but was travelling to Melbourne so had plausible deniability for turning up at the garage, it was great to see her but also obviously a bit sad all round.
    • Skyline R33 Series 2 sedan tail lights in excellent condition. These are becoming harder to find, especially in this state.    BOTH SETS ARE IN FANTASTIC CONDITION (REFER TO PHOTOS)    ✅ No broken covers or cracks ✅ Lenses are in flawless condition ✅ All rear mounting lugs intact ✅ Comes complete as pictured ✅ Perfect for restoration, replacement, or upgrade   These lights are ready to go, no surprises just quality OEM parts.   These are definitely one of the better sets we have seen in a while. With minimal wear and tear they will come as you see. Bear in mind they are not brand new they are almost 30 years old now. To find them in this condition isn’t easy they can only be obtained on the second hand market.   Australia Wide Postage Available At Buyers Expense. Silver Set:$850 Grey Set:$850 PM Me for purchase or any other questions  IMG_2166.dng IMG_2165.dng IMG_2172.dng IMG_2173.dng IMG_2174.dng IMG_2179.dng IMG_2180.dng IMG_2260.dng IMG_2258.dng IMG_2259.dng IMG_2261.dng IMG_2266.dng IMG_2273.dng IMG_2274.dng IMG_2276.dng
    • Unsolicited advice? Keep the engine as close to stock as you can. Nothing wrong with adding some boost and making a little more power, but given where you are, you really don't want to try to make it into a monster. I can't imagine the roads are up to it, and the lack of locla support when it grenades will be a ball ache. FWIW, If there is a dyno around that you can access, then brand new injectors are a good idea, which will lead you to (at least) putting a Nistune in it, which will allow you to put an R35 AFM on it, all of which will make it possible to make it much much nicer to drive and live with.
×
×
  • Create New...