Jump to content
SAU Community

Sau:nsw - Monthly Meet February - Sunday Morning Cruise & Breakfast


Recommended Posts

Noise defect as in epa? If so that sucks so much dick. I hate them, normal defects in don't mind, they make me money. Yet epa defects are so crap as they idiots at the testing facilities don't know what there on about and aren't trained correctly. Had to ask a customer of mine where the egr valve is installed on the exhaust manifold in his cobra was......

Annnnnnnnnnd I can't make this event now =( got a family/church event that I'm not allowed to miss... Sorry guys & girls!! And I was really looking forward to it =(

Annnnnnnnnnd I can't make this event now =( got a family/church event that I'm not allowed to miss... Sorry guys & girls!! And I was really looking forward to it =(

tell your family you're on a pilgrimage to see God's beautiful creation known as the RNP ;););)

I'm sure they will understand

  • Like 1

Okay so Austi Beach have finally got back to me with their set menu. The idea behind this is it will be easier to bill as everyone will be seated at one big table. They have amended the menu to include the Big Breakfast which Im sure is going to be the top pick.

If there is any issues, do let me know.

Thanks.

Breakfast Group February 2015 (1).doc

  • Like 1



  • Similar Content

  • Latest Posts

    • Yeah, it's getting like that, my daughter is coming over on Thursday to help me remove the bonnet so I can install the Carbuilders underbonnet stuff,  I might get her to give me a hand and remove the hardtop, maybe, because on really hot days the detachable hardtop helps the aircon keep the interior cool, the heat just punches straight through to rag top I also don't have enough hair for the "wind in the hair" experience, so there is that....LOL
    • Could be falling edge/rising edge is set wrong. Are you getting sync errors?
    • On BMWs what I do because I'm more confident that I can't instantly crush the pinch welds and do thousands of USD in chassis damage is use a set of rubber jacking pads designed to protect the chassis/plastic adapter and raise a corner of the car, place the aforementioned 2x12 inch wooden planks under a tire, drop the car, then this normally gives me enough clearance to get to the front central jack point. If you don't need it to be a ramp it only needs to be 1-1.5 feet long. On my R33 I do not trust the pinch welds to tolerate any of this so I drive up on the ramps. Before then when I had to get a new floor jack that no longer cleared the front lip I removed it to get enough clearance to put the jack under it. Once you're on the ramps once you simply never let the car down to the ground. It lives on the ramps or on jack stands.
    • Nah. You need 2x taps for anything that you cannot pass the tap all the way through. And even then, there's a point in response to the above which I will come back to. The 2x taps are 1x tapered for starting, and 1x plug tap for working to the bottom of blind holes. That block's port is effectively a blind hole from the perspective of the tap. The tapered tap/tapered thread response. You don't ever leave a female hole tapered. They are supposed to be parallel, hence the wide section of a tapered tap being parallel, the existince of plug taps, etc. The male is tapered so that it will eventually get too fat for the female thread, and yes, there is some risk if the tapped length of the female hole doesn't offer enough threads, that it will not lock up very nicely. But you can always buzz off the extra length on the male thread, and the tape is very good at adding bulk to the joint.
    • Nice....looking forward to that update
×
×
  • Create New...