Jump to content
SAU Community

Recommended Posts

I have sold my GTR so no longer need the parts/spares.

All parts are located in Brisbane south side, and inspections are welcomed, just message me on here or email me and I will try and get back to you as soon as I can.

I will post at buyer's expense, so if you are located elsewhere and if you are interested, please contact me for a quote on freight.

Images are located for all the parts here: http://www.sau.com.au/forums/gallery/album/5783-classifieds-images/

Thank you.

BCNR33 GTR Skyline RB26DETT Camshaft/Timing Covers

One of the camshaft covers has been damaged with a part of it snapped off.

$150

FJ20 Cylinder Head with front cover/oil pump

Bare FJ20 cylinder head

Front Cover with Oil Pump

$500

Trust/Greddy Hard Intercooler Pipes

Only have two of the pipes out of the set of four.

$100 each

Greddy T78 33D Turbo

http://www.trust-power.com/spec_swf/02turbo/Turbo%20Chargers.htm

Split pulse design, rated at 720hp

Removed due to going to a twin turbo setup

$1500

Greddy Type R Wastegate

http://www.trust-power.com/02turbo/waste_gate_valve.html

http://www.trust-power.com/spec_swf/02turbo/GReddy%20%20Waste%20Gate%20%20Valve.htm

Removed due to going to a twin turbo setup

$500

Greddy Type R Split Pulse High Mount Exhaust Manifold

http://www.trust-power.com/02turbo/sus_turboex_manifold.html

http://www.trust-power.com/spec_swf/02turbo/Sus.Turbo%20Ex.%20Manifold.htm

Stainless Steel Split pulse design.

Removed due to going to a twin turbo setup

$1000

Greddy Heat Shield

http://www.trust-power.com/02turbo/heat_insulator.html

Removed due to going to a twin turbo setup

$50

R33 GTR Dash Cluster

Reason for removal was swapped out for an aftermarket cluster.

Has 26,000km on Odometer.

$300

R33 GTR Fuel Pump Controller

$50

R33 GTR YAW Rate Sensor

$100

R33 GTR RB26DETT Alternator

$100

BCNR33 GTR Skyline N1 Centre Triple Gauge Cluster

R33 GTR N1 centre triple gauge cluster

Worked perfectly before being removed from the vehicle

$100

Nissan Skyline GTR RB26DETT Carbon Fibre Timing Belt Cover

Unknown Brand

I impulse bought it when I was in Japan.

$50

Nismo Skyline BCNR33 Series 3 Front under Diffuser

http://www.nismo.co.jp/products/catalogue_2014/#page=265

Genuine Nismo S-Tune aero body kit front under bumper spoiler for the Skyline BCNR33 R33 GTR Nismo S-Tune front bumper.

Paid around $1000 and then realized it wouldn’t fit!

$500

Nissan Skyline BCNR33 GTR N1 RB26DETT Air Box and Snorkel

Nissan Skyline BCNR33 GTR N1 Air Box and Snorkel

K&N Air Filter

$250

RB26DETT Air Flow Meters

These were working fine before being removed from the vehicle, one is genuine and one looks aftermarket.

$100 for the pair

Trust/Greddy 3.7” “Power Extreme” Ceramic Coated Stainless Steel Exhaust with Custom Front/Dump Pipe

Hardly used, was only pulled off due to going back to a twin turbo setup on the car.

Custom made dump/front pipe to suit 4 Bolt turbo exhaust flange. No catalytic converter. :whistling:

$600

KSP Racing Equipment / Attain Carbon Kevlar Rear Bumper Cover to suit Nissan Skyline R33 GTST or GTR

http://www.ksp-eng.co.jp/ATTAIN/exterior/36.html

Brand New still in box

KSP/Attain Brand

Carbon Kevlar

$150

Rasty FRP Boot for Skyline R33 GTR/GTS-T

http://www.rasty.tv/pro/trunk.html

Flat Truck Style painted in QM1 White

Some Cracks in the paint where the wing was mounted.

Very light

$450

R33 GTR Front Lower Arms

Stock R33 GTR Front lower arms with ball joints.

$150 for the pair

Nismo Clear Indicators

Brand New Still in Box.

$80

R33 GTR R200 Competition Diff

Brand New Cusco 2 way Center

Brand New Crown Well and Pinion

Trust/Greddy Extended High Capacity Diff Cover

http://www.trust-power.com/16power_train/diff_cover.html

http://www.trust-power.com/spec_swf/05engine/DiffCover_Up_Grade_Kit.htm

Diff Cover has also been modified to clear a close fitting exhaust

4.11 Ratio

$2000

R32 GTR Dash Speedo

Reason for removal was only due to being swapped out for an aftermarket cluster.

52,000km on Odometer.

$250

R32 GTR Factory Suspension

Inserts and springs.

They were removed while they were still in good working cond.

$400

R33 GTR ABS Unit

Removed from the car only due to installing a pedal box set up.

$250

R33 GTR Washer Bottle and Motors

Very good condition.

$50

R33 GTR RB26DETT Cylinder Head

Complete cylinder head with coil packs.

Was running perfectly and was only pulled off the engine with the intent to build the bottom end, never happened.

$1250

RB26DETT Ind. Throttle Bodies and Plenum.

Was running perfectly and was only pulled off the engine with the intent to build the bottom end, never happened.

$400

RB26 Starter Motor

Was working perfectly and was only pulled off the engine.

$100

R33 GTR Sump and Factory Front Diff

Was running perfectly and was only pulled off the engine with the intent to build the bottom end, never happened.

$300

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The fancy pants red shock tower brace is finally incoming from MX5 Mania, getting it shipped from 'Merica has been a long and problematic process, and GWR, the 'Merican supplier will not ship directly to consumers outside of the US, Mania basically had to order a heap of them, the colour choice was silver, or red, and we all know anything red adds 5 killerwasps of dynotorques..... Whilst it does fit over a 2.5, and I've seen a few photos and videos of it being installed and fitting, google also says it might get real close to the FAB9 intake front runner, people in the US says it does fit with the FAB9 intake, except for one person who said it slightly touched.......so there is that.....LOL..... As it seems that I am the first in AU to have this combination of parts there's no local knowledge about fitment, so I'm just a willing guinea pig in this endeavour, I'll cross my fingers and toes and hope for the best In other news, I ordered stuff from China  on the same day I ordered the 23° silicone bend from Victoria, the stuff from China arrived a day ago, the 23° silicone bend is still travelling around Australia thanks to Australia Post, and "may" be here next week
    • Very good news...I contacted Racebox about it last night. My car is a 2016 so remains to be seen if it is compatible, requires a TCU swap, or is impossible.
    • What ECU are you running? This is probably the biggest question. If it's a PowerFC, I'd probably change the ECU and get something newer that will handle the injectors in a nicer way.
    • FYI: Racebox RE7R Custom Tunes Released!   https://goracebox.com/.../2017-infiniti-q50-q60-re7r-tcm...   FOR GEN 2 (21+) VEHICLES, PLEASE SEE NOTE AT BOTTOM See more   But whomever tuned your car is the tuner you should go back to, AMS, Sonictune or BT Tune....
×
×
  • Create New...