Jump to content
SAU Community

Recommended Posts

  • 4 weeks later...

Just a few updates.

Went to get it tuned to get it to run better and found out it had a leak from the gasket on the intake manifold.

And because this used to run gas i had blocked up the holes on the runners that the gas was injected into. So while i had the inlet mani off etc i thought id replace it with one without holes.

What a shitty job it is to do! But all done and will go in for a tune again this week sometime

Also replaced my front seats with GTR ones.

Looking for some rear seats in good nic if anyone has any

post-33454-0-86397500-1440467806_thumb.jpg

post-33454-0-89764000-1440467813_thumb.jpg

post-33454-0-59103400-1440467821_thumb.jpg

post-33454-0-20459200-1440467829_thumb.jpg

bought a 32 GTR spoiler and boot to put on....

Got the car tuned, dyno sheet below.

Still having a problem with the car ummm, cutting out and hesitating then like bunny hopping and wont rev. Tuner thinks either the AFM or the crank angle sensor.

Will find an AFM asap and try that. easiest thing to try

post-33454-0-63506700-1441334647_thumb.jpg

post-33454-0-67088700-1441334652_thumb.jpg

  • 1 month later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Maybe also really stiffly sprung track cars. Get the inside wheel up in a corner and all the fun stops. Also me sometimes (rarely) when I have to stand on the brake to convince the diff to drive the wheel that is still on the ground when I'm trying to diagonally get over severe driveway entrance, etc.
    • I feel like I'm missing something. You had an authorised installer come out and install a new alarm. Post install the car doesn't start, and you aren't getting the installer back to fix what they did wrong?
    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
×
×
  • Create New...