Jump to content
SAU Community

Recommended Posts

Corey, what about jeeps? Few Cherokees around? Also looking at pajero's prado's pathfinders and maybe x5's

Stay away from jeeps unless you like catching on fire

Yes to prados, and x5's seem nice

Pathfinders are a pain to repair, especially the transfer cases and the electrics. Early Pajeros are good, the new ones had a recall from memory for overheating problems but they are weeding them out, gearboxes in them are strong but if you are going to tow campers/boats/caravans/race cars you may need to invest in airbags as they sag in the ass real bad

Leaning towards pajero's now. Only looking at putting 150ish on the ball. That only drops the rear of the zook 25mm so doubt the paj will sag any further. Unfortunately recently found out our car is good for 85kg only. Spewin cos it tows it well

Something like this Trev? Pajero's depreciate far worse than Prados so you can pick up a relatively late model one in good condition for considerably less $$

http://www.carsales.com.au/dealer/details/Mitsubishi-Pajero-2006/OAG-AD-7904802/?Cr=6

One of our mechanics had one, did 400,000 kms without too many dramas.

  • Like 1

120 Series Prado would be a good tow vehicle as well if you can find one at a comparable price to a Pajero.

http://www.carsales.com.au/dealer/details/Toyota-Landcruiser-Prado-2005/AGC-AD-18325346/?Cr=5

Petrol of course ;)

  • 3 weeks later...



  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...