Jump to content
SAU Community

Recommended Posts

Awww you're awesome too Manne ! I love a guy with long hair , my high school crush all

With long hair [emoji28] but they didn't like me back

Used to have long-ish hair in highschool til uni...with few shades of colours too haha...then cut short since 08/09....some days I see my old photos and think I should grow it again haha....my boss says no every time I float that idea lol.

Edited by colin.ssc

Used to have long-ish hair in highschool til uni...with few shades of colours too haha...then cut short since 08/09....some days I see my old photos and think I should grow it again haha....my boss says no every time I float that idea lol.

Lol why not ? Bet it looks good on you ! Grow it [emoji13]

Bloke with long hair - Sexy ! But must be neat and tidy and reggae kinda look [emoji28]

What ingredients are in it?

Milk, heavy cream, 2 whole eggs, 2 egg yolk are the base. I'm pretty sure the egg and cream were too much. Gonna try a recipe with less egg to no egg and see.

Lol why not ? Bet it looks good on you ! Grow it [emoji13]

Bloke with long hair - Sexy ! But must be neat and tidy and reggae kinda look [emoji28]

Lol, longish hair with facial hair don't go too well together on me. Need facial hair to look older. Have clients asking if I'm 21.

  • Like 1

Milk, heavy cream, 2 whole eggs, 2 egg yolk are the base. I'm pretty sure the egg and cream were too much. Gonna try a recipe with less egg to no egg and see.

Lol, longish hair with facial hair don't go too well together on me. Need facial hair to look older. Have clients asking if I'm 21.

What ???? Homemade Ice cream ? Like for real ? Wow ! [emoji119][emoji119][emoji119][emoji122]

Longish hair with facial is very very sexy Collin ! post-139458-1464583281707_thumb.jpg




  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...