Jump to content
SAU Community

Recommended Posts

So while working on my r34gtt I had the intake manifold and runners off, I had rags in the intake ports in the head but nothing in the cooling jacket. I was stripping some wire when a piece of rubber insulation maybe 5mm wide and 10mm long fell into the head, the water port between cylinder 1 and 2 ..

After a few failed attempts to remove it, it can't even be seen now. It felt like it was going great downwards towards the thermostat but even last ditch attempt at blowing compressed air down there hasn't made it reappear. How harmful could this be?

I figure worst case it damage to water pump or block up a small water gallery.

Waterpump and thermostat are removed BTW post-90047-14458284639591_thumb.jpg

I'm in the wouldn't worry about it boat. Put it back together drive it. If it overheats start to worry then. If it runs fine but it still bothers you, flush the system after its been pressurised a few times. If it still bothers u after all that, light up a stick of dynamite and move on to your next car:)

Prob melt and seal up a leak ;)

Wouldn't worry about it, I bet millions of new cars come off production lines with insects and metal and other crap in their coolant, fuel, and even oil systems and nothing happens.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
    • If it (the code) wasn't still current, it should have gone away by itself by now. No, nothing it 10/10. But it is quite likely. Everything else to do with the ignition could still be responsible (which is wires and connectors). The car is an old piece of shit now, so all the wires and connectors are also old pieces of shit.
×
×
  • Create New...