Jump to content
SAU Community

Recommended Posts

So my standard clutch finally gave up so purchased a lightened flywheel and a 6 puck clutch kit. Installed it all last weekend, the only thing not replaced is the bush inside the crank as I was running out of time. Everything has been bolted up correctly, surfaces checked, there was a little bit of machining material left on flywheel dowels but cleaned it all up so the pressure plate definitely sat flush. Gearbox was supported the whole time so clutch shouldn't have bent, there's no judder/shudder and car drives fine.

Been driving the car easily to get everything to bed in so haven't pushed it yet but have noticed that more vibrations are coming through the car, especially at around 4k rpm mark where it starts to gets a bit crazy.

I have solid mounts for the gearbox and in the subframe, a bit more noise came through but no biggie as I've been using them for over a year.

At first I though it could be the driveshaft being unbalanced but it also happens in neutral at around 4k rpm there a big vibration starts coming through the car, which keeps increasing as the revs go up. The vibration is of high frequency, as if something is out of balance slightly.

I can't feel this vibrations on the clutch nor through the shifter.

Anyone experienced something similar after a clutch job? Any tips of pin pointing the location of this vibration?

Edited by ErOR

Did you mark the driveshaft flanges before you separated them, then put them back at the same orientation? If not, try disconnecting, turn through 90 degress, then reconnect.

Did you mark the driveshaft flanges before you separated them, then put them back at the same orientation? If not, try disconnecting, turn through 90 degress, then reconnect.

Agreed, try this first something about them being balanced. I put an exedy kit in my car and don't have an issue (flywheel and cushioned clutch plate)

The clutch is from a reputable store in NZ, not actually sure on the brand or where it came from. The gear is definitely of high quality, could be a bad batch. Will go see the guys there today and have a chat about it.

No I didn't mark the driveshaft flanges but remember this vibration is happening in neutral, driveshaft shouldn't have anything to do with this vibration as far as I know.

I'm leaning more towards pressure plate cast being out of balance or something similar.

So your saying a drive shaft that is physically connected to the diff and wheels doesn't spin in neutral?

Check again young grass hopper [emoji106]

Do these vibrations come if the car is sitting still and you rev to 4K as you mentioned that's when it's worse?

Edited by Gcjosh

So your saying a drive shaft that is physically connected to the diff and wheels doesn't spin in neutral?

Check again young grass hopper [emoji106]

Do these vibrations come if the car is sitting still and you rev to 4K as you mentioned that's when it's worse?

Only the engine, flywheel and pressure plate spin when in neutral. Clutch plate, input shaft, driveshaft etc are still.

Sorry OP - I didnt read carefully enough and missed it was in neutral. So agree it sounds like out of balance flywheel or pressure plate.

If it happens when your stationary test it with the clutch pedal in and out, if its there in both situations id be getting the flywheel and pressure plate checked for balance.....

  • 1 month later...

After the 6 puk melted to the flywheel I got the flywheel and pressure plate balanced and all the vibrations are gone now.

Lessons learned, experience gained...

Also switched from ceramic to kevlar and it's so much nicer to drive around streets, 6 puk ceramic can stay for the track.

Edited by ErOR
  • 3 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
    • Does it also misfire equally when revving?   Josh is very correct in what you should do. The coilpack harness wiring loom itself is a known problem due to its age and the number of heat cycles it has gone through. Throwing parts at a vehicle to diagnose the issue isn't a smart or good way to do it. Secondly, you may have a bad coil pack, you pop replacements in, they fix that issue, but messing with the harness breaks it, so the issue persists. So now you think "well it wasn't the coil packs" and have to continue chasing your tail, potentially swapping back in your shit coil packs and returning the good ones (yes, I've seen people do this because 'it wasn't the problem' and they want to save money). And suddenly, you've got two issues with the same symptoms...   Diagnose, don't use the spare parts shotgun.
    • Well the articals keep saying a Q50s (Skyline in Japan) with a new Manual gearbox. I like the talk about the new looks with the round tail lights. I hope they bring back the retro look like they did with the Z
    • Off the back of feedback we have decided to mix up this next Motorkhana at Avalon to have some targeted skills practice for beginners to advanced. Saturday 6th September 2025 8:30am Capped 26 entries Standard Entry Fee: $89 Members Entry Fee: $55 (SAU Victoria Only) Entries Close: Friday 5th February  Where: 55 beach road Avalon. https://maps.app.goo.gl/HNUE3EuNue3sJxh38 Entries: Limited to 26 entrants (Passengers allowed over the age of 14 with a signed disclaimer and same safety gear) Disclaimer: Download  Please electronically sign and email to [email protected] or print and hand in and Driver Sign In. To compete in this event you will require A valid  AASA General Speed licence or (Day license via the AASA Website for $50) MA Licenses are no longer accepted by AASA https://aasa.com.au/  A helmet, long sleeve clothing and a 1KG mounted fire extinguisher recommended (But not Mandatory). Further details within Supp Regs on the enty link. Entry Link > https://www.sauvic.com.au/entry/deca/20250906 You can bring and have a passenger in the car but they need to comply to the same safety and clothing as driver. Bring your car and get to battle others, win, lose or draw. I can guarantee you will have lots of fun. Any questions email [email protected] Entry List: 1.Anna S 2. Luke S 3. Jesse Givens-Lamb 4. Luca Stamatescu 5. Madeleine Stamatescu    
    • Wanna rewrite all of that in, say, 2 or 3 separate sentences, so that we can read it?
×
×
  • Create New...