Jump to content
SAU Community

Recommended Posts

You could try wrecking yards around your area. I haven't got one to sell you but what kind of spoiler are you looking for? The low profile ducktail spoiler or the R34 coupe spoiler?

IMG_6069.jpg

maxresdefault.jpg

If it's the latter then any 2 or 4 door GTT's spoiler, in addition to the GT spoiler, would fit.

Edited by Wordsmith
  • 3 weeks later...

hey burger whats the quality of there stuff like? been searching for a reasonable knock off GTR wing for a while and they look pretty decent.

sorry to hijack your thread.

hey Pearcey I have a knock off GTR wing and it's same as real one even pulls apart the same there pretty good got mine from a body shop in QLD pretty happy as I could fined a real GTR one :) Edited by DanMac34
  • Like 1

Oh that sounds awesome, most i've seen online look very average. Would you happen to have details of said body shop? :rolleyes:

post-141096-14538790512066_thumb.jpg

It coast me $400 including shipping

55 Moss St, Slacks Creek.QLD 4127

Phone: (07) 32901148

[email protected]

A&J Autostyle

It's just not called gtr wing cause it's a copy

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...