Jump to content
SAU Community

Recommended Posts

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Been up to the cross a few times, good views on a clear day. Most times found it crowded with tour buses and the restaurant there seem to be a little overpriced for not much chop. I also don't recall any barbies or anything.

However, what about a meet up, there or Macedon township or somewhere else. Then drive over the mountain and take the back way into Hanging Rock and stop for a...ummm...picnic.

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7687784
Share on other sites

Did someone say Picnic....at Hanging rock...ummmm. Sounds familiar :)

Sunday 13th March is Labour Day Weekend.

If we can get some idea of numbers then we can arrange a few meeting points and route.

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7687996
Share on other sites

Since this is out in the west i'll be up for whatever happens. Also checked out Hanging Rock website and they charge 10 bucks per car entry. It's been 25 years since i was last there all they had then was some barbies, dunnies, a racetrack, oh yeah and a big rock.

As i said, March is a little tricky, I've penciled in the 13th, so I'm keen.

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7688890
Share on other sites

I'm definitely up for a cruise. Haven't been able to make many meets. I'm down for whatever, except march 13th LOL :-P

The following Sunday, the 20th, is the Melbourne Grand Prix.

I assume a few will be going or watching from home so the cruise turnout would not be so good.

Can we have a show of hands for the 13th vs say 27th?

Link to comment
https://www.sau.com.au/forums/topic/462912-stagea-cruise/#findComment-7692683
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
×
×
  • Create New...