Jump to content
SAU Community

Recommended Posts

Hey guys, so I've been having some issues with my 07 V36 350GT Sedan for awhile now. The issues are on and off but now its present every day and it's starting to annoy the shit out of me.

1) At cold start / first drive for the day, when driven, the car would stutter (where RPM fluctuates and you can feel the car bucking). This issue is now present every time I drive if the car has been left to cool down. Initially I thought it was a vacuum issue but found no vacuum leaks.

There were talks about transmission issues and even engine oil issues in 350/370z forums but I am not sure if this is it.

2) Lately when I start the car, cranking it talking longer, some days it tries to crank, while rpm is v low it starts popping a few times. Stepping on the accelerator tends to get the crank going.

This lead me to think it's fuel pump, injector or coil packs not working properly.

I get no error codes whatsoever and am at my wits end. My mechanic said maybe try replacing the fuel pump first and go from there. OEM pumps looks to cost around $650 and up. Not sure if I'm looking at the right thing.

Would love some opinion re the issues but also opinions on if I should get OEM fuel pumps or look at after market ones?

Link to comment
https://www.sau.com.au/forums/topic/463132-fuel-pump-injector-coil-pack-issues/
Share on other sites

Might be a bit of a long shot, but have you been able to monitor the battery voltage from a cold start?

I had an issue on my wife's J31 Maxima a few years back where it would be hard to start sometimes and then splutter for the first 5sec or so after firing. After that it ran fine.

Turned out the battery voltage was low due to a lot of short trips (wife works about 3km from home), and it wouldn't run properly until the engine RPM was high enough to allow the alternator to supply the correct voltage. After taking the car for a long drive, it would be fine for a few weeks.

We just make sure it gets a reasonable drive on the weekends now and it hasn't been an issue since.

Also explains why the car eats batteries every 2 years or so.

Edited by sonicii

Hmm, I did think of that, since initially the first issue did not happen all the time but I do about 350km to 400kms per week with half of that done on the weekend. I will check again on this though. Thanks for the suggestion....keep em coming!

For the first point in the OP, it only happens in first few min of driving.

Edited by colin.ssc

To stop the engine stuttering with a cold engine, try running Castrol Edge 0w40 oil. Worked 100% for me! (I had engine stuttering with both Castrol Edge 5w40 and Mobile 1 0w40 - the only other oils I have used in the vq35hr) The theory has something to do with oil density switching the VVT on just a bit to early ie during the 2-3 minute warm up mark. These engines aren't supposed to use VVT until xxx operating temperature, and are apparently fussy on oil choice. I personally also recommend OEM filters (get them from Nissan for the 350/370z) to ensure flow rates and relief valve pressures are correct.

Anyway there is a massive mamojam thread over here:

http://my350z.com/forum/maintenance-and-repair/307878-sputtering-during-warm-up-32.html

As for your slow engine cranking - I'd think battery first and starter motor second.

I'd like to hear what works out for you eventually!

Edited by Rufus007

Thanks, will give that a try and battery! Will update as I go.

Be sure to do one at a time so you know what fixed it.

And if you need a new pump forget about the OEM unit you can get a better one cheaper from Scotty:

  • Like 2

Could be the pump or fuel filter, but more likely the spark plugs, or just water in the IPDM, that's where I would start.

Faults like this can get expensive if a mechanic is involved, especially if he hasn't worked on VQ's much.

Could be the pump or fuel filter, but more likely the spark plugs, or just water in the IPDM, that's where I would start.

Faults like this can get expensive if a mechanic is involved, especially if he hasn't worked on VQ's much.

How do we treat for water in IPDM? And can you PM me re fuel pumps or filters? Heard you make em?

This comment is spot on - change one thing at a time. I'd still like to know what works for you in the end, mostly because I once had the same issue from your description (sorted now though).

<p>

Be sure to do one at a time so you know what fixed it.

And if you need a new pump forget about the OEM unit you can get a better one cheaper from Scotty:

That looks very mild. Mine is alot worse. 0w30 indeed helps, stuttering nearly gone but still a little. I guess maybe it is the VTC issue? Will do more testing over the months (when I find more time).

Ordered a fuel pump from Scotty, hopefully that solves the cranking issues.

When it gets bad, it's very very bad, like something is breaking, so yes I will look into it. I've read that thread before just never bothered and thought about it too much / didnt think that was the issue as the VTC's don't turn on til it's hot enough...who knows. Annoying AF!

Castrol Edge 0w30

Starting fine as in I had issues at cranking. On the stuttering issue - the stuttering is still there, very mild, quite delayed. I think (just my opinion) that the stuttering is happening on a certain temperature. Because of the 0w, this temp is achieved at a later time and because by that time I am already driving a longer distance without braking or letting off the throttle, I don't experience the stuttering.

Before this service the stuttering can only be felt if and when I accelerate / accelerate after letting to go of throttle (around the estate areas) etc if that makes any sense.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
×
×
  • Create New...