Jump to content
SAU Community

Recommended Posts

Alright so about 2 days ago ive changed the coolant and actually put coolant into the car as before it just had water running through it, my car has been overheating roughly about 15-20 mins after driving depending on how i drive it if i thrash it it starts climbing but if i drive normally it keeps cool then slowly starts to heat up. Ive started turning the heater on full blast as that sorta fixes the overheating problem while im driving but does this mean it could be the thermostat thats screwed or could it be something more like a blown gasket or something? ive noticed that some hoses on top of the engine have some crystalised brown stuff leaking from them, could thise be the old coolant thats clogged up and crustified there blocking the flow of oolant into the engine? 

also another question are any other struts from other nissan skylines interchangeable with the struts i have now? 

Please any help is appreciated and needed!!! 

Thanks :)

Link to comment
https://www.sau.com.au/forums/topic/465870-problems-with-my-r34/
Share on other sites

Have i bled it? like Burped it?-.......No i forgot too, hopefully that fixes it.

Fluid level is good as the reservoir tank and radiator are always full and only require little bits of coolant to be added after running and turning off but i might need to burp it.

The bottom hose is hot 

and the top hose is firm when its up to temp.

Ive been reading and im thinking it could actually be a blown head gasket.

One day i overheated and my reservoir tank was boiling/bubbling/popping it was going nuts could that be head gasket?

If you haven't been using "anti-freeze" your system could  be full of rust and cr*p.

First try bleeding all the air out (search if you're not sure how).

Get a radiator shop (or your friendly mechanic) to put a pressure tester on the radiator to spot leaks or may tell you if there is a major leak from the head gasket. Have a look through the filler at your radiator core. May need cleaning or replacing.

Get a new radiator cap, sometimes they get old and the spring wont function thus not letting water into the engine at operating temp.
Also do a proper bleed, top up the reservoir past the full line. Top up the coolant, turn the heater on full and whilst the car is running loosen the coolant bleed screw near the front of the plenum until coolant comes out.
Just my 2c on what i would doc40737aa1b7a43fdb50d0c6ccd16e3d0.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 馃槀 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
    • Ah coolant overflow, previous discussions make way more sense now lol. 
  • Create New...