Jump to content
SAU Community

Recommended Posts

Hey what's up y'all, I'm new to the fourms but came on here due to frustration and a misfiring RB26. My 1992 Skyline GTR has a misfire that seems to be random. It does not happen upon could start from what I can tell. Checked the computer codes and they flashed all clear. I pulled the plugs and saw they were covered in black soot, some worse than others but all generally dirty. Replaced them with some iridium plugs from NGK gapped at .8, and that didn't fix it, then put some used but nice Splitfire coils on it, which seemed to maybe help a little but it could be placebo, also seemed to not wanna start with those coils in and low idle. The car is drivable but feels down on power and the misfire is pretty constant throughout the rev range. Only other thing I notice is she spits black smoke and it leaves these carbon specs all over the rear end. Maybe she's running too rich? I'm stumped and don't wanna put any money into it until I know what's wrong. Anyone have an idea? Thanks alot!

Link to comment
https://www.sau.com.au/forums/topic/479778-r32-gtr-random-misfire/
Share on other sites

2nd hand coils are not a diagnostic tool.

The other half of the ignition electronics is the igniter pack. It sits up on top of the motor getting cooked for 30 years.....it doesn't last forever.

The other other half is the coil pack wiring loom/connectors.

The other other other half is...how healthy is your alternator, battery voltage, when running?

The other other other half is that it could be a whole bunch of other things, from worn out CAS bearings, to an intercooler pipe/hose blown open (and hence running rich). But I would bet that the running rich shit is simply caused by the missing. If the fuel don't burn, because it wasn't lit, it looks rich.

1 hour ago, GTSBoy said:

2nd hand coils are not a diagnostic tool.

The other half of the ignition electronics is the igniter pack. It sits up on top of the motor getting cooked for 30 years.....it doesn't last forever.

The other other half is the coil pack wiring loom/connectors.

The other other other half is...how healthy is your alternator, battery voltage, when running?

The other other other half is that it could be a whole bunch of other things, from worn out CAS bearings, to an intercooler pipe/hose blown open (and hence running rich). But I would bet that the running rich shit is simply caused by the missing. If the fuel don't burn, because it wasn't lit, it looks rich.

Well that's my problem, I've done a lot of research but nothing really points to how I can test it to be sure. Voltage should be fine, is there any way I can pin point something like the harness or igniter before spending money on them? 

Take to a mechanic that has a dyno so you can test it under load with gas analyser up the spout, and look for spitzensparks around the coils and pull coil plugs off to see which is missing and then swap stuff around to see if the miss follows the coil or stays with the cylinder. And then swap to known good coils and/or ignitor. Just the usual things.

There is nothing more frustrating than remote control misfire diagnosis. Nothing beats having someone who knows what they're lookign at actually look at it while it's running.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I can see between the water jacket and cyl 3 there wasn't a hard line of combustion gas. It certainly appears that the issue is coming from there. Yes, checked the tension. All at 100ft lbs where I set them 5 years ago. These blocks can crack but generally when they have been over bored. Mine is only 0.5mm oversize at 89.5mm. They break between cylinders around the 91mm mark. No sign of that with mine. My gut feeling is the head gasket lifted a while back when the studs stretched and i bandaided it by retorquing the studs. It's finally let go.
    • My Nismo 1.5 churps a bit on reverse turns when cold, but besides that feels like a stock diff.
    • Yes, but, I paid cash and I'm pretty sure the receipt was in the bin 10 minutes after I got home Note to self, keep all receipts
    • Bunnings would have just handed you your money back on that one!
    • So, version 4 intake is on its way I was looking at these a while ago but at around $200 or more it was a little pricey for something that might not work, but, I had it in my watch list, but, I got a message saying it was on special, and I had a code thingie to use, it eventually came in at $120 delivered, so BAM, BUY NOW.....LOL I'll need to have a look when it arrives but I feel it will "look" better than what I currently have, as it comes with a PCV fitting, so I will be able to get rid of the alloy pipe that goes to the throttle body with the PCV fitting  Well, that's what the voices in my head are telling me  Oh, and this happened today Yeap, it was a Trojan, and it was cheap, so I headed back to the hardware store and actually spent a little bit more on a heavy duty,  one that was actually recommended by a plumber mate, a Cyclone one with a fibreglass handle that is actually rated for clay The broken shovel will eventually be "modified" into a short handle shovel
×
×
  • Create New...